VTR1000.ORG

If you need some help wiring it up here is a post when I figured out how to hook a Euro switch to US harness. http://www.superhawkforum.com/forums/technical-discussion-28/electrical-help-please-32453/ Let me know if you need help and I can run out and check on my bike. Good luck with swap :D :thumbup:

They are HRC/Dr Honda copies that I have for sale on ebay.

I had a run of these done and got some extra left over.

If anyone one wants a set PM me and I'll see what shipping would be, also the price will be lower.

It is ebay after all, might as well see how much I can get for them

Does nobody have at least an opinion on this? anything would be appreciated

Found the wiring diagrams

So I am in the process of switching over my US lighting control switch for the European ones, as they have the on/off position and passing switch. So far I think I got it right as most of the wires are just straight forward plug into old spot. The 6P is a direct plug in if I read the wiring diagrams...

Ok so if anyone could we need the length from to mid axle to the lower steering head bearing with the front end of the bike off the ground.

This would be much appreciated

corbin smuggler seat from the usa, could do with a re-trim, but there can't be many of these knocking around. http://www.ebay.com/itm/Honda-Superhawk-VTR-1000-VTR1000-CORBIN-Smugler-Seat-/351136752126?pt=Motorcycles_Parts_Accessories&hash=item51c161a1fe&vxp=mtr billet stacks from Canada.......

tony.mon wrote:Make sure that's a fully-extended measurement on both, as static sag can take up to 25mm off that.

Good point, measurement with the front end off the ground would be much appreciated as well

Seems a bit short from the steering stem to the axle.
Would that be maybe with a "0" on the end so 520mm ??

If so thanks for checking for me, much appreciated

Hi, Could anyone take measurement from the underside of the triple to the top or bottom of the front axle for me? Would be much appreciated. Silly me I forgot to do this when I removed the forks and now not sure where exactly they should be. Before you ask they are not the original forks so can not ...

Yeah I realize they are pricey for you guys, unfortunatly its the shipping across the pond that sucks and makes it that way.

I will email you the files I have, hopefully they will be of some use

Hey guys, Just an update for you. So we went ahead and got a few of these made, I do have a couple of extra ones if you are interested. Shipping from Canada unfortunatly would be about $170-190 shipped depending on if you want tracking or not. But if there is more interest than what I have I can sen...

Hey guys, I am getting some aluminum stacks machined http://www.superhawkforum.com/forums/general-discussion-30/velocity-stacks-32079/ and was wondering if anyone over here would like a set. The only thing is that the shipping to you guys across the pond would be expensive unfortunatly. Unless I sen...

As far as I know our CCT's are powered by weak springs that fail hence the switch to Manuals, not hydraulic at all.

No need to block any oil passages as far as I know, unless I'm totally wrong

I have the 2 front and 3 rear wheel bearing if you want them. Only problem would be the shipping price from Canada.

Let me know if you are interested and Ill figure out the shipping.

My bike had only about 23,000km when they were removed and they still turn great, can send pictures your way as well