VTR1000.ORG

Removed the plastics to straighten the fins on the oil cooler and thought, why not new masters on both sides, braded lines, and a new clutch slave?

Has anyone here signed up for the FEC (Front End Chatter) Scotland tour in May 2022? I was entertaining the idea until I looked at the air fares. The hotels and bike rental were one thing, but combined, for me, it was more than I was willing to cough up. I have, for a long time, wanted to travel Eng...

Is the sound the same when the engine is cold or hot?

https://www.nomartirechanger.com/vs-90-black-10mm.html Have been using these for a number of years. No problems with the fitment into the wheel. I'm guessing you'll be able to find a similar stem on your side of the pond. A word of caution, my fault for being to cheep, I went through four tire chan...

How many miles since the switch to higher octane?

Check your oil for fuel dilution before you run the engine.

I've lived, as an adult child, three geographically different places. Two that didn't change the position of the hands on the clock (Hawaii and Arizona) and one place that did (Alaska). I really don't understand the supposed rational why, as it doesn't do anything useful. Nice not having to go throu...

Sounds like an air lock. Fill the rad at the filler cap on the side stand, then start the engine. Wearing gloves, squeeze the large pipe that runs through the frame, you should see the level drop in the filler neck. Add more coolant when that happens and repeat. Then hold the throttle at 3k revs, a...

Stevie Ray Vaughan. Doing Voodoo Chile. Great ones seem to leave early.

I have used this and is near perfect.
https://www.colorrite.com/wizardresults.cfm

Made a stand a few years ago using the info from this thread. It has been utterly indispensable. Every time I use it I'm thankful for this site. A huge thank you to the OP Jazzscot.

daz350 wrote: ↑Sun Sep 01, 2019 4:42 pm Hi i am in the process of replacing my swingarm and shock linkage.Would it be ok to replace linkage nuts and bolts with stainless

While stainless might be fine, in such a critical area I would only use OEM or exact equivalent.

This might be helpful.
https://www.superhawkforum.com/forums/m ... ide-23751/

Where did you source the exhaust mounts from?

Hey 8541 Hawk. I can't use the PM function. Have an email in to the admin to enable it.