VTR1000.ORG

Ok it wasn't anything I was doing wrong. Or at least the front end being out wasn't from the way I put it back together. The triple tree is bent

So time to start looking for another one.

Thx for the info thou

Hey all I'm sure I’ve done something wrong, so I’m just looking for advice. Some how in my low side at the track I managed to bend one of my fork tubes and twist the upper triple clamp out of alignment. So I ordered 2 new tubes and installed them along with RaceTech valves and Ohlins springs (not ...

http://www.sebimoto.com/

You can also find race fairing here. I have them on my track VTR the fit is good and they survived a crash very well

Thx for the tip, but after banging my head off the wall for a while I figured it out. And the Dynojet springs are about 1/2 the length of the stock springs and are easy as pie to install :D Taking the air box off and removing the carbs on the other hand was not!! But after a few chose word and ...

Hey all, I'm new to the board but this looks like as good a place as any to post my question. Now I'm trying to install a Dynojet kit but I can't figure out how to remove the fuel needle from the vacuum slide. I have a service manual on order but thought I could install the kit without it. Guess I ...