VTR1000.ORG

double oops but at least i stripped her and rebuilt her without any physical help but loads of written help thank you all especially chris who gives lots of encourage ment

the answer to no start the kill switch was on 2003 model the bike spins over but no fire but she ranb so ill fill her with proper coolant not water and set tick over which is very low sincew i had to altter cables to take of carbs
im going to order new plugs too

thanks all day off from stress today but i will start investigation tomorrow

cheers hawk will try tomorrow
law

well down to last thing to do get the bugger running she made noise sounded like she was going to run but died do the carbs take long to fill ( my gsx 1100 takes ages fromm empty carbs to start up) so first thing i did was put battery onto charge some ignition systems take 12v to fire then its dow t...

thank you one and all all bike needs now forkbrace finish installing two timing plugs put back on then pluck up the courage to start her

good going man

thanks chris brake lines all done clutch line next finishing line insaite

well ! jones the funeral man, was driving his hearse to give an old man his final trip to the chappel. as he turned the corner to go through town to the cemetry he hit a pothole, his foot slipped and he went full throttle. The back end of the hearse sswung out rapidly the bump uncatching the tail ga...

yesterday i saw a guy maching down the main road holding a bycicle over his heads






it was a rally

yes i know stu but this has gone on since before christmas ha ha at least its over god both incidents sound really bad cheers
man all the best
law

well timing done craqnked over by hand qall looks well i hope , new choke fitted on rear carb, new levers fitted ,shock spacer fitted, pair valve removed and blanking plates fitted front one looked as if bolts would snap but they never,manual tensioner refitted to rear pot,early air box fitted. i st...

i bought a yam rectifier annd needed to join honda wires to a yam plug it was easy three yellow to the thre lower yam wires and the pos neg to the upper two plugs thejust use soldering and heatshrink wrap instructions came with the plug anyway i havent run the bike yet but its also got new generator

yea if dowel had gone down engine trouble is i dont know if dowel had rubber seal on it or if i never put it on thanks for the information chris and thanks for all the support it means a lot to an aged recluse :D in my life i have never had this much trouble it must be an age thing but taliho im off...

well i got to the point where bike just needed tank on and it was ready to roll its mot and its taxed then in garage i went to put itt on paddockm stand which ive done a few times ok .paddock stand i picked was the wrong one it had a twist to bang bike goes over and smashes her fairing and the back ...