riser clipons, what height needed? - what's recommended?

General Bike chat
User avatar
MacV2
Posts: 17418
Joined: Sun Jan 21, 2007 12:07 pm
Location: Grain

Re: riser clipons, what height needed? - what's recommended?

Post by MacV2 »

On the thrid wrist this is the bars on BigBird... RWU Blade Forks with gull wing yoke. Don't know if they are the std bars or not.
Big Bird Bar 1.jpg
Making up since 2007, sometimes it's true...Honest...
User avatar
AMCQ46
Posts: 16535
Joined: Mon May 11, 2009 4:54 pm
Location: Worcestershire / Warwickshire border

Re: riser clipons, what height needed? - what's recommended?

Post by AMCQ46 »

thanks Mac,

those TBR clipons look interesting, looks like you can change the angle too, so 2 degrees of freedom compared to the woodcraft 1.
AMcQ
User avatar
fabiostar
Posts: 7542
Joined: Sat Jun 01, 2013 3:53 pm
Location: sunny belfast

Re: riser clipons, what height needed? - what's recommended?

Post by fabiostar »

on my blade front end with a flat top yoke iv Apex 3" riser bars, real good bit of kit and can adjust them any way i fancy. well worth hunting a set out Al :thumbup:

they sit under the yoke aswell.
the older i get,the faster i was :lol:
Post Reply