Engine bolt lock nut

TravisZack · Post by **TravisZack** » Wed Apr 16, 2014 7:07 pm

This little bad boy

Is this the correct tool to remove it? Guessing the 20mm end is what I want.

http://www.ebay.co.uk/itm/261399577161? ... 26_rdc%3D1

If so is there anywhere I can walk in and buy one rather than buy online?

Thanks

Wicky · Post by **Wicky** » Wed Apr 16, 2014 7:16 pm

Get a socket and a grinder and make one at home.

mattycoops43 · Post by **mattycoops43** » Wed Apr 16, 2014 7:56 pm

The same tool is listed as a moped flywheel or clutch locking tool, they are about £5 on ebay. I got one and it does the same job.

tony.mon · Post by **tony.mon** » Wed Apr 16, 2014 7:57 pm

You need two sizes, as the other engine mounts are different.

mattycoops43 · Post by **mattycoops43** » Wed Apr 16, 2014 8:00 pm

Cant remember the sizes, but I got one like this and it works fine.

http://www.ebay.co.uk/itm/Pit-Dirt-Bike ... 27e0dada47

VTRDark · Post by **VTRDark** » Wed Apr 16, 2014 9:13 pm

This is the one. Cheap as chips and does the job.
http://www.ebay.co.uk/itm/Oil-filter-Nu ... 2322513e1b

http://www.vtr1000.org/phpBB3/viewtopic ... ol#p248970

(:-})

TravisZack · Post by **TravisZack** » Wed Apr 16, 2014 9:37 pm

Thanks guys, it's just to fit some crash protectors so I only need that one off for now.

VTR1000.ORG

Engine bolt lock nut

Engine bolt lock nut

Re: Engine bolt lock nut

Re: Engine bolt lock nut

Re: Engine bolt lock nut

Re: Engine bolt lock nut

Re: Engine bolt lock nut

Re: Engine bolt lock nut