Any Info Please.

[pariah]

Just managed to a set of micron cans of a guy on e bay

They are complete with hangers and link pipes, however the thing is. Will I need to buy new gaskets and clamps or will my original ones still fit as I onle renewed these not long ago.

Rick

[marravtr]

prob better with new gaskets (or silicon seal) just done my mates but had to buy new clamps (micron cans)

[Wicky]

Depends what you've already got fitted. My Microns, with separate link pipes just slip onto the existing header section. The gaskets are inside the original honda one piece can/connector pipe so leave them be - so you can refit for MOT etc.

I would recommend using Mikalor Supra Fully Stainless Steel W4 clamps (55-59) over the crappy honda ones, especially if you ride in winter.

http://www.stagonset.co.uk/fasteners?ca ... ose|Clamps

[pariah]

Hi Wicky.
many thanks for the info, I have found these on e bay. The only difference i can see is that these are W2 clamps (390106115974) . These are three times cheaper than from the place you mentioned. Plus free postage as well . Would they be just as good ?

Rick

[Wicky]

The bolts on the w2/w3 are zinc coated, while the w4 is fully SS hence marine quality. You'll appreciate the difference if you ride over winter through salted roads.

Buy 3 or 4 of the w4 Mikalors and they'll last you a lifetime.



3 years old and as good as new

Hi Wicky.
many thanks for the info, I have found these on e bay. The only difference i can see is that these are W2 clamps (390106115974) . These are three times cheaper than from the place you mentioned. Plus free postage as well . Would they be just as good ?

Rick