LED Indicator resistors

[strachg]

Does anyone know what the resistor rating is to get your led indis to flash correct. Going to try and get them through my work.

[bigrich]

im not sure but personally from experience would spend £20 and buy a motrax plug in and play relay . Used one myself and is so so easy!

[strachg]

ah didn't realise there was such a thing cheers will do that

[tony.mon]

Other than that Hein Gericke do some nice little resistors on ali heatsinks- were about £3 each, probably gone up a nadge now.

EDITNo, still at £2.99 each!
http://www.hein-gericke.co.uk/shop/adva ... 9utuvm8r1r

Or for a cheap option, wire up a normal filament indicator bulb in parallel and leave it sitting under the seat- one each side.

[Jbrebel]

That’s what I did on my VTR Tony

Just popped each bulb into a plastic film tub (back when camera's used films... ) and taped them up so they didn't inadvertently stick to anything under the seat or get cracked. Left plenty of spare wire on and pushed them out of harms way.

Sorted

[sirch345]

Like Bigrich, I didn't bother messing about either and just fitted a Motrax flasher relay for LED's like this one:-
http://cgi.ebay.co.uk/MOTRAX-FLASH-LED- ... 2a0557bf74

I see there are cheaper flasher relays available, but don't know how good they are:-
http://cgi.ebay.co.uk/MOTORCYCLE-LED-IN ... 519028d274

Chris.