Front CCT and Haynes info ???

[Jens]

So i changed the read CCT. wass np at all. Working on the front cct now.

In the guides on this forum. it says i should turn the engine 1.5 or so until the mark FT alignes.

In the Haynes manual it says the same, but also says that the marks on the crankcase cover should align with the FI and FE marks !!!

I tryed this but cant get em to align at all when the mark are on FT.

any one noticed this before ? and what do i have to work after, the haynes info or the info on this forum ?

Jens

[Jazzscot]

You did turn it anti clockwise didnt you??

one and a quarter turns

[Jens]

yes i turned it anti clockwise.

[Jens]

FORGET my question, i found the problem. i looked again at the rear cct.

[Jazzscot]

To coin a Brittish phrase which may not translate very well.

You Plonker!!!!!!!!