Stumped by black plastic panel

[andre5030]

Just finished replacing ccts and front exaust valves all sorted rebuilt bike runnin great, but.... lol
I have this black plastic panel thingy think it goes somewhere round the front fairing near the light but cant figure where it fits for the life of me.
It has a semi circular cut out and a few holes that i think are for cables and somthing that looks like it clips in somewhere at the other end.
Can anyone help?? lol

[sirch345]

There's two small-ish plastic infil pieces that fit into the front of the heat shied that sits under the carbs. May be it's one of those Best post a photo if it's not,

Chris.

[benny hedges]

it goes on the right hand side on the front, under the airbox and secures with a clip on one side that slots under the rear plate & one 6mm plastic screw under the frame on the right hand side, about level with the back of the front cylinder.

it is just a blanking plate to fill the gap where the cables go through. the bike will run without it lol, but you will know there is a bit missing.

[andre5030]

I think u could be right there cause it has 2 inserts. Oh well of with a few bits again.

Cheers Chris!