I was at snetterto t'other day and on the sharp corners I kept dragging the footrests, which kind of put me off. I'd love to get some rearsets but at £300 ish, its a bit steep. Does anyone know where I can buy some jack up plates or some simple raisers ? I have seen these on other bikes for around the £50 mark, well inside my budget !! Help appreciated !!footpeg raising ??
-
freshfunkmeister
- Posts: 69
- Joined: Sun Dec 07, 2003 9:33 pm
- Location: Epsom, Surrey,England.
footpeg raising ??
I was at snetterto t'other day and on the sharp corners I kept dragging the footrests, which kind of put me off. I'd love to get some rearsets but at £300 ish, its a bit steep. Does anyone know where I can buy some jack up plates or some simple raisers ? I have seen these on other bikes for around the £50 mark, well inside my budget !! Help appreciated !!As soon as I read about the dangers of drinking too much, I immediately gave up reading.
www.classicreplicasuk.co.uk
All donations will go towards the completion of the car. Thank you.
www.classicreplicasuk.co.uk
All donations will go towards the completion of the car. Thank you.
-
Stormin Ben
- Posts: 1234
- Joined: Sun Dec 01, 2002 12:23 am
- Location: Birmingham
I'm in the same boat mate
My first fix has worked a treat, some replacement footpegs from M&P
Have a look at their website http://www.mandp.co.uk
Into bars and rests
Select MFW
Scroll down to the tapered ones £19.99
They increase the ground clearance hugely, mine have only just started to touch down -after the bellypan ground out and just fractionally before the exhaust header!!
Next stage is to bolt them directly to the standard footpeg mount and do away with the flippy-up mounting bit
Ben
My first fix has worked a treat, some replacement footpegs from M&P
Have a look at their website http://www.mandp.co.uk
Into bars and rests
Select MFW
Scroll down to the tapered ones £19.99
They increase the ground clearance hugely, mine have only just started to touch down -after the bellypan ground out and just fractionally before the exhaust header!!
Next stage is to bolt them directly to the standard footpeg mount and do away with the flippy-up mounting bit
Ben