rough running after manual cct change...

[MacKrell17]

So I started the storm today for the first time this year - been too busy etc...

Anyway whilst it's been sitting around I've been doing a few mods - fettled forks, new rear shock, braided brake lines etc... and the swap to manual CCTs. Fired her up today (fired on the 3rd turn so well impressed) and I can hear a faint knocking sound. Difficult to hear over the zorsts but definately mechanical as it get faster as the revs go on - can't decide if it's something I've knackered whilst changing the bits or whether it was always like this and just needs a bit of tune up.
Doesn't sound gravely, can't feel anything untoward through the bars and it's not all that loud - As I say difficult to hear over the zorsts and they're not particularly loud as all the baffles are in at the moment.

Opinions please....

[Serlant]

could be the clutch but with it knocks as a desription doesn't tell much video possibly?

[steveb]

I thought clutch too, pull it in when ticking over and see if the noise is still there.

[tony.mon]

If it didn't do it before it'll be something to do with fitting the manuals.

Did you set the engine in the right place before undoing the standard ones?

[benny hedges]

maybe just want tightening up a bit.
did you follow the guide on here or use haynes?
or just guess

[MacKrell17]

I followed the guide in the knowledge base. very good they were too, and the whole process was much quicker than I thought.

I can't remember any weird noises from before (apart from a whining noise which it's had since new). It may well be that I'm just being paranoid. I do need to check the valve clearances but I can't see it being that. I guess the sensible thing is to check the timing etc..... or take it for a burn and see if it goes bang - decision depends on the weather this weekend!