Abba Stand copy

[jono49]

My Copy "Abba" stand is nearly finished, It looks a bit Blacksmith built!... but costing nothing but the time to do it Who cares

http://www.ixxra.co.uk/v-web/phpBB3/dow ... &mode=view

http://www.ixxra.co.uk/v-web/phpBB3/dow ... &mode=view

http://www.ixxra.co.uk/v-web/phpBB3/dow ... &mode=view

[pariah]

Give that man a cigar. Well done mate. nice coat of red paint and would look like a bought one. I like peeps that have a go and can do things for themselves.

[jono49]

Thanks Pariah Just tried it out this morning after finishing it last night, I have found the best way is put the Rear paddock stand under to lift it, slide the abba type under and assemble and tighten the screw, then gently lower the paddock stand and grip the belt on the seat and gentle let it roll forward until it rests on stands own legs! I removed the belly pan and put my trolly jack under the sump and it lifted the front nicely and spot on for a tyre change etc! when I do the tyre change I'll post some piccies then

[Jazzscot]

Good stuff mate, I have one just like that.

[jono49]

I would post a piccie of my wheel balancer I made but I have not earned enough brownie points yet.............How many posts before you get the privilege ????

[AMCQ46]

that is a well made replica

just one comment........should there not be support legs fitted on one side so it goes over center and is stable on a triangle base.........cant see one in the pictures, but imagine you have already copied that from the ABBA

like the pictres in this thread link
http://www.vtr1000.org/phpBB3/viewtopic ... 63#p173860

[jono49]

Just added the legs that day but I still have to post the piccies yet!........And yes the legs look like the original to!