Just fitted and done the spacer mod but!!!!!!!

[Vtrkidda]

AS it says theres a but my bike leans a bit far over on its stand its pretty stable though ,Can I get away with welding a foot to the bottom of the stand to make it stand upright more

Or have other members been ok with it,I remember a post by
" benny of hedges all mighty" did warn me about this but me no listen

Ive used 2 3mm alloy spacers 10 mm slots cut in from ebay a fiver done the job ggggggggreat

Thanks in advance

[YETI]

I wouldnt weld a foot on itll tip over the other way
try a couple of inches .
though mine leans a bit just dont park up on a slope youll be fine
regards
YETI..

[Vtrkidda]

I should of seen that coming a foot I mean erm a bit of metal a foot

[leevtr]

Use a sidestand puck, or 2. Stick them under the seat, always handy anyway.

[Kev L]

Over on the Superhawk forum they reckon a CBR1000RR sidestand circa 2003-4 fits right on and is longer therefore holding the bike more upright.

[agentpineapple]

you could always ride with a rear paddock stand strapped to your back.......

[lumpyv]

whats the handling like with the spacer?

[seb421]

whats the handling like with the spacer?

I would say it doesn't feel as stable at high speed, triple figure's and that,

but corner turn in feels better like it wants to fall into the corner better, easier and tighter

[Vtrkidda]

whats the handling like with the spacer?

Havnt tried it yet mate high speed is not what I'm about I Like 0-100 speed
Front sprocket next