Intake manifold vac nipple thread size...???

Johnny Wishbone · Post by **Johnny Wishbone** » Wed Mar 23, 2005 10:31 am

Am I right in saying the thread size on the vac return nipples (easy Tony!!

) are M6???

tony.wilde1 · Post by **tony.wilde1** » Wed Mar 23, 2005 10:39 am

i think theyre about this size ok?

Johnny Wishbone · Post by **Johnny Wishbone** » Wed Mar 23, 2005 10:50 am

Super!! One nipple for the front cylinder and one for the back! Sorted!

tony.wilde1 · Post by **tony.wilde1** » Wed Mar 23, 2005 11:01 am

Johnny Wishbone · Post by **Johnny Wishbone** » Wed Mar 23, 2005 11:11 am

If her right tit was threaded to M5, and her left tit was threaded to M6, would either of them fit in the vac port on the manifold, and if so, which one?

Seriously though, what was school like for you Tony?... something like, "if Mary has bigger boobs than Michelle, and Michelle has smaller boobs that Sue, does Sue have bigger boobs than Mary???"

tony.wilde1 · Post by **tony.wilde1** » Wed Mar 23, 2005 12:09 pm

school?whats that then?

tony.wilde1 · Post by **tony.wilde1** » Wed Mar 23, 2005 12:10 pm

m5 i think

yellafella · Post by **yellafella** » Wed Mar 23, 2005 7:51 pm

1/4 BSP ?

Johnny Wishbone · Post by **Johnny Wishbone** » Thu Mar 24, 2005 9:53 am

Your '?' is throwing me off as little here - 1/4" would make sense alright since most pneumatic fittings are imperial as standard, but I'm sure I read somewhere that vacuum gauge fittings were sold as M5 and M6...

I could just go out and get a couple of 1/4" BSP and M5/M6 bolts and try them til I get a fit, but I'm far to lazy to do something like that!

VTR1000.ORG

Intake manifold vac nipple thread size...???

Intake manifold vac nipple thread size...???

vac nips

nips

hmm

thread