How do I remove clip on internals?

[tasum]

got a replacement s/h clipon with no internals. how do I remove the internals from my old, and bent, clipon to pop in this one so I can stick the bar end on properly?

cheers for any help

[Rob]

I know it's tight but I'm pretty sure it just pulls out.

[AMCQ46]

There is a spring clip higher up the bars I think, take the grips off and the switches and see if there is a little cut out then you press in that to release the clip

[Rob]

Maybe like this?

http://www.manicsalamander.com/media/51 ... emoval.pdf

[tasum]

ta lads, and thanks rob for the piccies, will have a go this week when i 'm back at flattys, cheers

[Flatline]

Get some release spray down the end buddy

[lloydie]

you might want to try to remove the weights from the one i gave you
i tried but couldn't

[tasum]

you might want to try to remove the weights from the one i gave you
i tried but couldn't

yeh, but you're a big southern jessie, so no surprise there, now we know we can heave on it, flatty will have it out in no time

[lloydie]

Lol

[Flatline]

I dont mind getting it out, but I'm not sure I want you heaving on it

[tasum]

I dont mind getting it out, but I'm not sure I want you heaving on it

I'm sure i saw some needle-nosed pliers in your workshop, so no bother

[mr.john.coates]

Don't panic she said

I know it's tight but I'm pretty sure it just pulls out.

[sirch345]

To remove the internal bar weight you need to release (push in) the two little tangs. You can just see the top one sticking up in the picture where I've arrowed it, but there is a bottom one at 180* to the top one. You need to hold the bar in a vice while releasing both tangs at the same time with two small flat blade type screwdrivers, then with a third hand pull the weight out. When the weight is in the handle bar the little tangs sit in two small holes which you can see from the outside of the bar. If you force the weight out without releasing it first you will most likely break the tangs off, or at least one of them.


Chris.

[tasum]

all done, thanks to all for the helpful advice. I got Flatty's 9 year old daughter to pull out lloydiecbr's weights from his donated clipon, nice easy job for her.

Stuck the old clipon in the vice and 2 pulls later out it came and then stuffed them into the new clipon.

The bar end tightens up nicely even with the heated grips on, so ta lloydiecbr for the clipon and everyone for the advice.

[lloydie]

all done, thanks to all for the helpful advice. I got Flatty's 9 year old daughter to pull out lloydiecbr's weights from his donated clipon, nice easy job for her.

Stuck the old clipon in the vice and 2 pulls later out it came and then stuffed them into the new clipon.

The bar end tightens up nicely even with the heated grips on, so ta lloydiecbr for the clipon and everyone for the advice.

i could not get it out well done to her

and your most welcome