Have any of you got the complete front engine mount bolt plus all the little bits to go with it? I find myself in need of one.
Let me know if you do and how much inc postage
front engine mount bits
Moderator: VTRDark
Re: front engine mount bits
As a temporary bodge three or four years ago I used a length of M12 stainless studding and nuts.
I replaced it with a std Honda bolt and adjuster earlier this year.
It was fine, and of course didn't require industrial steam hammers or an angle grinder to remove it.
And about a tenner all in, with the washers.
I replaced it with a std Honda bolt and adjuster earlier this year.
It was fine, and of course didn't require industrial steam hammers or an angle grinder to remove it.
And about a tenner all in, with the washers.
It's not falling off, it's an upgrade opportunity.
Re: front engine mount bits
Not a bad idea tony bit I may as well do the job right first time. Not in a mojor rush but would like it sooner rather than later. If no one here has one and I can't source a second hand one I'll have to go brand new at the cost of nearly 50quid
Re: front engine mount bits
Hasn't Lloydie got one in his bag of bits he got the other day.
(:-})
(:-})
==============================Enter the Darkside
- lloydie
- Posts: 20923
- Joined: Mon Jan 17, 2011 11:16 pm
- Location: In the garage somewhere in Coventry
Re: front engine mount bits
Yep but that's for miss piggy and is already offered as a loan if neededcybercarl wrote:Hasn't Lloydie got one in his bag of bits he got the other day.
(:-})
Re: front engine mount bits
Not sure if I have the top one or not. I'll have to have a look.
I know I moved one the other day but think it may be the rear one...
I think the top one got buggered getting it out...
I'll check later & get back to you.
Mac
I know I moved one the other day but think it may be the rear one...
I think the top one got buggered getting it out...
I'll check later & get back to you.
Mac
Making up since 2007, sometimes it's true...Honest...
Re: front engine mount bits
Cheers Mac
Re: front engine mount bits
Your in luck...sort of.
I do have one, c/w the threaded adjuster bit & a nut (+a spare nut) but I do not have the castle nut.
It's a bit beaten up & is a bit corroded esp at the nut end but should clean up.
The thread at the nut end is a bit chewed up & the nut wont go on atm but re cut the thread & it should be ok.
As it's a bit beaten up I'll send it to you FOC, if you can use it great, if it's no good bin it.
PM me your addy & I'll get it posted asap.
Mac & Franks Spares Emporium. A sub division of Mac & Franks Acme Industries International Corp.
I do have one, c/w the threaded adjuster bit & a nut (+a spare nut) but I do not have the castle nut.
It's a bit beaten up & is a bit corroded esp at the nut end but should clean up.
The thread at the nut end is a bit chewed up & the nut wont go on atm but re cut the thread & it should be ok.
As it's a bit beaten up I'll send it to you FOC, if you can use it great, if it's no good bin it.
PM me your addy & I'll get it posted asap.
Mac & Franks Spares Emporium. A sub division of Mac & Franks Acme Industries International Corp.
Making up since 2007, sometimes it's true...Honest...