Harris rearsets

[chric]

To low? You should be able to adjust the angle of the dangle on the levers.



Sent from my GT-19505 using Telekinesis

Ill have a gander think my high levels may be in way though

[Jamoi]

Hey Chric, did you manage to adjust your lever in the end?

I've just been looking through the Moriwaki bible, god they made some sexy parts!

Sent from my GT-19505 using Telekinesis

[lloydie]

Hey Chric, did you manage to adjust your lever in the end?

I've just been looking through the Moriwaki bible, god they made some sexy parts!

Sent from my GT-19505 using Telekinesis

Yes they do and very hard to find too

[chric]

Hey Chric, did you manage to adjust your lever in the end?

I've just been looking through the Moriwaki bible, god they made some sexy parts!

Sent from my GT-19505 using Telekinesis

no forgot all about it going to have a look in morning as its too low and im relying on the front breaks more than i should.
if i cant ill contact harris like you and see what they say

[VTRDark]

Is it the gear lever adjustment you need Chris. On the Gear rod you have a banjo at both ends with a lock off nut. Unlock the lock off nut and undo the banjo and you can un-thread the banjo either end to extend or shorten the rod and then reconnect, tighten up and lock off the lock nut. Watch out for the reverse threads (anticlockwise to tighten). If your lucky you may get away with just unlocking the lock off nuts and spinning the rod part around to raise or lower the gear lever with no need to disconnect the banjo's.

(:-})

[chric]

thanks carl think i may have found the problem somet so simple but pissed me off a little bit
It will cost about 20p to sort out ill post pictures tomorrow