show us your rear :p
show us your rear :p
following up on my thread ( show us your (bike) helmet) I thought id do another as I have some new higher linkpipes for my bike and I think it looks alot better...... heres mine show me yours lol
excuse the cable tie lol
excuse the cable tie lol
vtr 1000 firestorm
Re: show us your rear :p
From that angle of the lower edge of your numberplate, I'd check that the subframe is straight....reggy5 wrote:following up on my thread ( show us your (bike) helmet) I thought id do another as I have some new higher linkpipes for my bike and I think it looks alot better...... heres mine show me yours lol
excuse the cable tie lol
Sorry to piss on your birthday cake, but it looks off to me, and it's often bent following a drop. Park the bike on a paddock stand and use a broom handle across the lower edges of the rear plastics.
It's not falling off, it's an upgrade opportunity.
Re: show us your rear :p
I agree it does look lopsided...before checking the subframe i'd check that the numberplate holes are straight,mine were 10mm out when i got mine..brother inlaw must of had the dogs eyes in when he did it instead of his..then check the subframe if the holes are ok
Re: show us your rear :p
Got to agree with you there Tony, unless it's just the nbr plate, there's something very wrong there you know what I'm like for fine detailtony.mon wrote:
From that angle of the lower edge of your numberplate, I'd check that the subframe is straight....
Sorry to piss on your birthday cake, but it looks off to me, and it's often bent following a drop. Park the bike on a paddock stand and use a broom handle across the lower edges of the rear plastics.
Anyway here's a couple of pics of mine.
But this is by far the best rear end I've ever seen
Like what you do
Do what you like He who wonders isn't always lost
Do what you like He who wonders isn't always lost
Re: show us your rear :p
As tony says though if you measure to bottom of tail plastics theres no need to check number platetattoo wrote:I agree it does look lopsided...before checking the subframe i'd check that the numberplate holes are straight,mine were 10mm out when i got mine..brother inlaw must of had the dogs eyes in when he did it instead of his..then check the subframe if the holes are ok
SH#T HAPPENS!!!!!!!!
Re: show us your rear :p
I don't like this one very much...
Making up since 2007, sometimes it's true...Honest...
- lloydie
- Posts: 20921
- Joined: Mon Jan 17, 2011 11:16 pm
- Location: In the garage somewhere in Coventry
Re: show us your rear :p
Just a one nightie was it !!MacV2 wrote:I don't like this one very much...
Re: show us your rear :p
Carpe diem, quam minimum credula postero
F3, 954 USD front, K Tech springs, Braced swinger, Penske shock, Six spoke Mockesini wheels, Harris rearsets, QaT, Flywheel diet!, A&L stacks, stick coils, K&N, FP Ti jets, lashings of Ti & CF
F3, 954 USD front, K Tech springs, Braced swinger, Penske shock, Six spoke Mockesini wheels, Harris rearsets, QaT, Flywheel diet!, A&L stacks, stick coils, K&N, FP Ti jets, lashings of Ti & CF
Re: show us your rear :p
Where do you attach your license plate to that? I have a few ideas where I can put MY license platecheekykev wrote:
- bigtwinthing
- Posts: 5577
- Joined: Mon Dec 17, 2012 7:52 pm
- Location: Hampshire
Re: show us your rear :p
missing the noise, not the vibes. However never say never!