CCTs

fire_on · Post by **fire_on** » Mon Mar 17, 2014 5:18 pm

Anyone know if Rider is still selling manual CCTs? Picked up his email address from the post on here but no response.

May just be busy etc but keen to get it sorted/done so I can get back to riding without constantly listening out for something going bang.

Kev L · Post by **Kev L** » Mon Mar 17, 2014 5:30 pm

ROAS hasn't logged on here since August last year. I know he had health issues previously mate. Might be worth looking elsewhere.

adewhitmarsh · Post by **adewhitmarsh** » Mon Mar 17, 2014 6:06 pm

Message me if you need help getting some manual ccts for your vtr.

fire_on · Post by **fire_on** » Mon Mar 17, 2014 10:07 pm

Hi ade, if you've got a source I'd appreciate it otherwise it's of to Ebay/google to see what I can trawl .

VTRDark · Post by **VTRDark** » Mon Mar 17, 2014 10:46 pm

http://www.vtr1000.org/phpBB3/viewtopic ... 16&t=22720

(:-})

adewhitmarsh · Post by **adewhitmarsh** » Tue Mar 18, 2014 12:08 am

I do have a good source for manual ccts, email me for details adrianwhitmarsh@yahoo.co.uk

fire_on · Post by **fire_on** » Tue Mar 18, 2014 12:29 pm

Email on it's way - Cheers

gl_s_r · Post by **gl_s_r** » Wed Mar 26, 2014 6:55 am

I am now getting to the point I can now probably start making stuff again... do people want me to make some of these and offer them out to the forum members?

agentpineapple · Post by **agentpineapple** » Wed Mar 26, 2014 6:58 am

gl_s_r wrote:I am now getting to the point I can now probably start making stuff again... do people want me to make some of these and offer them out to the forum members?

no....get back in your workshop and start making me some titanium goodies....

start with front and rear wheel spindles.....

seriously tho mark, how much could you produce manual cct's for?
because i'd rather buy them from yourself knowing they'll be top quality....

gl_s_r · Post by **gl_s_r** » Wed Mar 26, 2014 7:16 am

Depends on the costs of the bolt through the middle.

If you or anyone else can tell me anything about them that I need to know or help me make the first set to see they are right then I'll know from there but can't see them being expensive.. quite cheap in all probability.

Also this may be the chance for anyyone to have any input into a different design should they have any ideas to improve it for the better?

I for one put a PTFE insert into mine instead of the o-ring and when you tighten the locknut it squashes the insert and seals it.. don't know if this will work, seems to at the moment.

still, anything is open for debate and I don't mind making test parts for opinions..

VTR1000.ORG

CCTs

CCTs

Re: CCTs

Re: CCTs

Re: CCTs

Re: CCTs

Re: CCTs

Re: CCTs

Re: CCTs

Re: CCTs

Re: CCTs