Headlight fairing

[carmanbikes]

Hi All, Has anyone got a picture of the wiring behind the headlight with the nose cone removed, struggling getting the lugs on the nose cone to locate into bracket, Thanks

[Wicky]

Pg. 21/405 Cable & Harness Routing 1-17 In the downloadable PDF Honda VTR service manual from the workshop knowledgebase.

[VTRDark]

Now if you had asked a coiple of days ago I could have taken a better pick while I had the fairing off. Anyhow here's some I took earlier.
http://www.vtr1000.org/phpBB3/viewtopic ... 15#p218074

It's a bit tricky getting a good fit. Make sure the main loom is pulled back along the headstock/side of frame so you have as little as possible up front bunched up. It's also the way the two main bundles are held in the clips up front. Push these back as far as they will go.

(:-})

[carmanbikes]

Now if you had asked a coiple of days ago I could have taken a better pick while I had the fairing off. Anyhow here's some I took earlier.
http://www.vtr1000.org/phpBB3/viewtopic ... 15#p218074

It's a bit tricky getting a good fit. Make sure the main loom is pulled back along the headstock/side of frame so you have as little as possible up front bunched up. It's also the way the two main bundles are held in the clips up front. Push these back as far as they will go.

(:-})

Thanks Carl your a great help