Front Calipers

Stratman · Post by **Stratman** » Wed Feb 01, 2006 4:29 pm

Do SP 1 calipers fit the storm straght on?

Zer0Zer0 · Post by **Zer0Zer0** » Wed Feb 01, 2006 6:10 pm

No...........

cbr 600 front pots do though. and are a good upgrade,

Post by **firestorm_al** » Wed Feb 01, 2006 7:42 pm

Zer0Zer0 wrote:No........... cbr 600 front pots do though. and are a good upgrade,

Did I not see a picture of someone with K3 GSXR front callipers on a Storm recently?

Post by **firestorm_al** » Wed Feb 01, 2006 7:45 pm

Tokico Brake converstion. Bolt straight on, no messing about. GSXR600/750 K1-K3.

Zer0Zer0 · Post by **Zer0Zer0** » Thu Feb 02, 2006 9:20 am

nice 1 Al m8 ...do you know if the pots off the gixxer are a better upgrade than the ones from the CBR? my storm wears the standard nissins. ,braided cables and sintered pads.much improved over the stock set up. but as always
Im after that little extra.

Pete.L · Post by **Pete.L** » Thu Feb 02, 2006 1:31 pm

Or you can go and change the other End.
Cbr 1000 or Sp1/2 Master cylinder will give you one finger braking

Pete.l

Zer0Zer0 · Post by **Zer0Zer0** » Thu Feb 02, 2006 8:02 pm

Excellent smithers......

barrioplano · Post by **barrioplano** » Thu Mar 30, 2006 3:40 pm

Is Cbr 1000 or Sp1/2 master cylinder a bolt straight on as well?

xxxrated · Post by **xxxrated** » Thu Mar 30, 2006 6:03 pm

sp calipers are near enough a direct replacement. 5 minutes on each caliper with a dremel and your sorted. and there oh so much better than the stock setup

Zer0Zer0 · Post by **Zer0Zer0** » Thu Mar 30, 2006 9:11 pm

... HAI... CBR 1000 / SP1 /2 mastercylinder . is a straight swap..

jcdj · Post by **jcdj** » Thu Mar 30, 2006 11:28 pm

what model gsxr are they from ????????