VTR Project
-
- Posts: 710
- Joined: Sat Jan 16, 2016 12:07 pm
- Location: Slough, Berkshire
Re: VTR Project
Love the rear pegs, look great in black as do the Remus exhausts.
Think you might have gone a bit overboard with the rim stickers. Those ones I think two per side is plenty IMO. Great look as a whole though
Think you might have gone a bit overboard with the rim stickers. Those ones I think two per side is plenty IMO. Great look as a whole though
If it aint broke, get your bloody hands off it!
- lloydie
- Posts: 20921
- Joined: Mon Jan 17, 2011 11:16 pm
- Location: In the garage somewhere in Coventry
Re: VTR Project
Well done [THUMBS UP SIGN]
Now you've done with this get a move on with the Ducati
Now you've done with this get a move on with the Ducati
Re: VTR Project
Looks good Flatters, well done. Good to see that plate out and about again.
Carpe diem, quam minimum credula postero
F3, 954 USD front, K Tech springs, Braced swinger, Penske shock, Six spoke Mockesini wheels, Harris rearsets, QaT, Flywheel diet!, A&L stacks, stick coils, K&N, FP Ti jets, lashings of Ti & CF
F3, 954 USD front, K Tech springs, Braced swinger, Penske shock, Six spoke Mockesini wheels, Harris rearsets, QaT, Flywheel diet!, A&L stacks, stick coils, K&N, FP Ti jets, lashings of Ti & CF
Re: VTR Project
Well done Flatters, glad you got there
Chris.
Chris.
Re: VTR Project
Over the last week or so I have refurbished the bottom of the forks and changed the oil
The forks have already been "sorted"
Now to get the sag correct
Also fitted new tyres, luvly
The forks have already been "sorted"
Now to get the sag correct
Also fitted new tyres, luvly
Re: VTR Project
This is where a trim clip remover comes in handy. You don't break clips then.I need the plastic clips that hold the wiring loom in place
I don't seem to be able to remove them from the old frame
http://www.ebay.co.uk/itm/SNAP-ON-Trim- ... SwhQ5XQe-B
And as for the engine mounting castle nuts those tools must have cost a small fortune. The following would have done it.
http://www.ebay.co.uk/itm/150899605019? ... EBIDX%3AIT
Good to see that plate again. So what colour is the bodywork eventually going in...White. The matt Black screen looks good. I might have to get one of those myslef, I like that.
==============================Enter the Darkside