Does the MCCT have to be so long. I was going to pull mine to bits and convert them myself and was wondering why you have a long screw sticking out. I assume that you would not need to adjust them that much. thought I would try and make mine as small as possible.
Robert Charlton
Manual CCT
-
robertisinoz
- Posts: 10
- Joined: Thu Apr 28, 2016 2:50 pm
- Location: Adelaide, Australia formerly Newcastle, England
Manual CCT
2002 Honda VTR1000
2006 Suzuki DL1000
Past Bikes
Yamaha TDM900, Yamaha RD350LC, Suzuki Freewind650, Suzuki Bandit600
2006 Suzuki DL1000
Past Bikes
Yamaha TDM900, Yamaha RD350LC, Suzuki Freewind650, Suzuki Bandit600
Re: Manual CCT
No, the bolt only needs 5mm of thread showing after it has been installed and adjusted to the correct tension.
I'd suggest you install it, set it up correctly, then uninstall and shorten by the required amount.
I'd suggest you install it, set it up correctly, then uninstall and shorten by the required amount.
It's not falling off, it's an upgrade opportunity.