Rich man, poor man

Sham · Post by **Sham** » Tue Aug 26, 2003 8:49 am

I have a Haynes VTR manual but it doesn't say where the mixture adjustor screw is??!

Just out of curiousity where is it, and which way do you turn it to enrich and which way to lean??

Yours in utter ignorance

Sham

Fireman on a Storm · Post by **Fireman on a Storm** » Tue Aug 26, 2003 10:29 pm

If there was a mixture screw we would not need dyno jet kits.

CaperJ · Post by **CaperJ** » Thu Aug 28, 2003 10:16 am

http://www.bluepoof.com/motorcycles/how ... stem_mods/

Sham · Post by **Sham** » Thu Aug 28, 2003 11:38 am

Thanks mate -
Slightly more helpful than Mr Fireman!

Sham

Fireman on a Storm · Post by **Fireman on a Storm** » Thu Aug 28, 2003 10:33 pm

I am not a mechanic.
My reply was more a question than a solution to your problem.
Sorry I should have worded it a bit better.

To end confusion can you adjust the mixture, or do you need the dyno jet kit?

Sham · Post by **Sham** » Fri Aug 29, 2003 7:48 am

Hi mate,

I was just curious as my Haynes Manual tells me you can adjust the mixture but it doesn't say how -just goes on about boring emissions regulations which we all care so much about with are NOT FOR ROAD USE cans straped on!...

Sham · Post by **Sham** » Fri Aug 29, 2003 7:49 am

Hi mate,

I don't have a dynojet kit -may consider one soon though -at the moment just looking at the carbs in general -gonna give them a good seeing to (!!?) and may adjust the needles depending.

Ta

Sham

VTR1000.ORG

Rich man, poor man

Rich man, poor man

I might be wrong!

Carbs of course theres a mixture screw checkout this site

Thanks CaperJ

Sham

Fireman

Fireman