Dyno Jet and set up in Swindon area

rmh · Post by **rmh** » Thu Jun 15, 2006 2:33 pm

Any recommendations where i can get a Dynojet kit and set up in the Swindon Area ? Anywhere within about an hour or so...

Thanks
Rob

Rincewind · Post by **Rincewind** » Thu Jun 15, 2006 2:37 pm

http://www.debben.co.uk/acatalog/VTR1000.html

lists a dynojet kit

dunno where you can get it done tho'

rmh · Post by **rmh** » Thu Jun 15, 2006 2:45 pm

Blimey that was a quick response !!

Looking for Dyno, K&N Filter "and" setup...not sure i'm tech enough to do it myself and want it to run real smooth with an even improvement over the entire rev range and running good with the Carbon Scorpion exhausts !!

Cost is not too bad though...
Thanks
Rob

Rincewind · Post by **Rincewind** » Thu Jun 15, 2006 2:57 pm

yea always good to know the cost, my localbike shop said the kit would cost @Â£150, maybe if it had 4cylinders......

vtrsteve · Post by **vtrsteve** » Fri Jun 16, 2006 2:17 am

Keep an eye on ebay for dynojet and K&N, I got a dj kit for Â£50 then bought a DJ kit WITH K&N for Â£77 and sold the first one on.

K&N at Â£25 at mo....
http://cgi.ebay.co.uk/Honda-VTR-firesto ... dZViewItem

rmh · Post by **rmh** » Fri Jun 16, 2006 8:25 am

Hmmm.... not sure about the one on fleabay..... USED !?!

I know they can be cleaned and oiled etc but Â£25 + Â£10 P+P (Bit bloody cheeky) for a second hand one of unknown state ?

Think i would rather hang out for a new one...

The closest Rolling road setup place i can find is PDQ near Maidenhead....
Was hoping for something closer, but has anyone any info on these guys ??

Thanks
Rob

Rincewind · Post by **Rincewind** » Fri Jun 16, 2006 12:30 pm

i think xxxrated has one for sale since he binned his bike, don't think he'd had it on long

was in the for sale section

Pete.L · Post by **Pete.L** » Fri Jun 16, 2006 8:41 pm

Hi Rob

There's a place in Keynsham that's a real V twin specialist. I've only heard of them by reputation (from the SV1000 forum

) but I've not heard a bad thing about them.
I've also got a mate I went to school with whose got his on rolling road in Samwell Bristol He hasn't had a load of firestorms through but he does Know his stuff.
I'm off for the next week (bloody work

) but if you want I can look up some details when I get back.

Pete.l
Err PM me if you need them incase I forget

rmh · Post by **rmh** » Mon Jun 19, 2006 10:16 pm

I have found the Web site for JHS Racing in Keynsham but know nothing about them....they look really good at SV`s so the Storm should be a doodle for them, especially as all im looking for is some fettle (DynoJet / K&N filter) and service and a bit of a dyno setup to make sure im getting the best from the Scorpion Carbons.

They feel good at the moment and are well ard noisy... but you never know i they could be better unless you check....

Thanks, any more info appreciated

Rob

Jaglifter · Post by **Jaglifter** » Tue Jun 20, 2006 5:03 pm

Hi

I picked up a dynojet kit off ebay. Not fitted it yet though. Cost me Â£110, with K&N filter.

A heard from a reliable source that Steve Lynham (out near the Crem.) is installing a Dyno.

Pete.L · Post by **Pete.L** » Thu Jun 22, 2006 2:13 pm

rmh wrote:I have found the Web site for JHS Racing in Keynsham but know nothing about them....they look really good at SV`s so the Storm should be a doodle for them, especially as all im looking for is some fettle (DynoJet / K&N filter) and service and a bit of a dyno setup to make sure im getting the best from the Scorpion Carbons.

They feel good at the moment and are well ard noisy... but you never know i they could be better unless you check....

Thanks, any more info appreciated

Rob

That's the one's.

I haven't bee there but they have a really good rep from what I've heard.

Pete.l
See if you guys can get a group discount for two