what have you done to your "bike" today

[Duffy1964]

well today i fell out with mine for the last time and want it away from near me

Not again what’s it done now?


Sent from my iPhone using Tapatalk

[fabiostar]

well today i fell out with mine for the last time and want it away from near me

Not again what’s it done now?


Sent from my iPhone using Tapatalk

aaah bollox its back to square one, same problem with running like a diesel

[sirch345]

Well I didn't do it all today but I did finish it today... found up around London, it had taken a tumble not to long ago and had been parked up since... I spotted it on the marketplace on the book of faces and enquired about it near 2 months ago but didn't follow anything up then 4 weeks later I get a random message asking me if I was interested and it was an offer I couldn't refuse.. as miserable as it looked in general the damn thing is really tidy and clean underneath.. so a bit of yesterday and today was devoted to giving old boy a make over and get ready for MOT.

I have found the photo I was looking for. I think it could be the same bike, what do you all think

Chris.

[MacV2]

Rode Nue Red home from Chez Jonesey in Ramsey...

Trundeled up there yesterday for a vist & a bit fun with airguns...as you do...



Roads busy thanks to some incosiderate cagers smashing into eachover...

[fabiostar]

brought mine to the dyno today to get answers .

went pretty well. ok it was a pig to ride to it, it ran so rough at times it broke its chain, and nearly didnt get me home it run so bad but ,i mean thats not bad lol

[thelens]

brought mine to the dyno today to get answers .

went pretty well. ok it was a pig to ride to it, it ran so rough at times it broke its chain, and nearly didnt get me home it run so bad but ,i mean thats not bad lol

hmmmmm sounds like my bike two weeks ago ! I know it sounds daft... but.... you may have put diesel fuel in it !!!!!
Mine ran too... but it ran hot and with lots of white smoke. It could well be worth draining and refueling.
not much of a cost to do so

[fabiostar]

no i made sure it was petrol today, iv done diesel before lol

[Bennyboy]

I will be fitting, a new clutch master cylinder, lighten flywheel, rear sets, new braced swing arm, radial calipers and a few more things

[MacV2]

Leaving for work this morn...No dipped beam on me cheap chinky purchace LED bulb...High beam working so rode in with that on...

Didnt seem to make much difference to cagers getting out of the way but hey ho it was raining & shite traffic...

Got home fitted a normal bulb & all is fine...I was wondering if it was the switch playing up but no it was the bulb...Now in the bin !

[MacV2]

Fresh oil in custurd, needs a treat now & then, 65k on the clocks now...Next on the list it needs a new front tyre as it has actualy squared off a tad...

Nue red got somew lovin'...New SBS sintered pads for the Brembo stoppers & with much help from Jonesey who kindly came over to give me a hand, put some shiney new Needle steering head bearings in.

Will give it a run tomorrow to bed the pads in & check the steering isnt to tight/loose...

[tony.mon]

Took it for a ride to see the salesman in the Croydon aprilia shop.

[Commando77]

Used my angled carb tool to have a proper go at idle mixtures. Surprised how little effect the screws have after 2T out. Had my gunson timing light as rev counter and it looks like one of the guages is down... 1250 on the clocks = 1100 on the light. Don't suppose I can trust either but it let me measure a 50 to 70 rpm drop.
Off to Brighton for the Ace burnup sunday.. Might keep up with mate on 96 blade.
Still, the K tech springs are the business, no preload to speak of but they feel lovely wallow gone and the ride is better.

[TaxiDriver]

Took it for a ride to see the salesman in the Croydon aprilia shop.

Naughty..........

[MacV2]

Fresh oil in custurd, needs a treat now & then, 65k on the clocks now...Next on the list it needs a new front tyre as it has actualy squared off a tad...

Nue red got somew lovin'...New SBS sintered pads for the Brembo stoppers & with much help from Jonesey who kindly came over to give me a hand, put some shiney new Needle steering head bearings in.

Will give it a run tomorrow to bed the pads in & check the steering isnt to tight/loose...

Test run completed all all is well in the world of NueRed...Stoppers check...headstock check... Didn't lock up on the brakes or the pads fall out...No knocking on the steering stem, bars free, turns nicely with no notchiness, don't wobble no hands...

[thelens]

Fresh oil in custurd, needs a treat now & then, 65k on the clocks now...Next on the list it needs a new front tyre as it has actualy squared off a tad...

Nue red got somew lovin'...New SBS sintered pads for the Brembo stoppers & with much help from Jonesey who kindly came over to give me a hand, put some shiney new Needle steering head bearings in.

Will give it a run tomorrow to bed the pads in & check the steering isnt to tight/loose...

Test run completed all all is well in the world of NueRed...Stoppers check...headstock check... Didn't lock up on the brakes or the pads fall out...No knocking on the steering stem, bars free, turns nicely with no notchiness, don't wobble no hands...

Yayyyyy nice one