Help my storm will not run

Atkinspa · Post by **Atkinspa** » Wed Oct 15, 2003 5:53 pm

Having installed a stage 1 dynojet kit, the bike starts and idles fine but will not throttle. The engine just dies, or runs a rough as hell.

I have checked the carb slides and they both slide to the closed positon from fully open the same time,with out snaping shut, I assume this means the diaphrams are ok. The pilot screws oar out 2.25 turns each, and there are no other signs of leaks

Ayone got any ideas.

Pete.L · Post by **Pete.L** » Fri Oct 17, 2003 9:00 am

What pipes have you got on?.

If you are running std pipes try mix screws 1 3/4 turns out. Needles circlip on 4th groove down from the top (or 5th without bottom washer will lessen hiccup around 4k rpm if using K&N filter) and 170 main jet.

Or for best results put your hand in your pocket and get it ran up on a dyno

Pete.l

delmeekc · Post by **delmeekc** » Fri Oct 17, 2003 4:32 pm

Do you mean in neutral and as soon as you apply any throttle it cuts out?

if so then check the obvious:

that the vacuum fuel tap is working properly.

that the choke is working properly and not open at all. Check that the outer cables are seated properly.

Del.

Atkinspa · Post by **Atkinspa** » Sun Oct 19, 2003 9:56 pm

Del

You were right I had connected to the vacum pipe to the wrong place on the fuel tap ( that will teach to label things properly). Had it sorted on a dyno now runs great well worth the the expsense got 109BHP at the rear with 190 mains and a K&N.

Thanks all, for your help.

Paul