Gear shifter linkage

beesfan · Post by **beesfan** » Tue May 01, 2007 9:04 am

I'm making a box of stuff to send to the powder coaters and am currently stuck on the gear shifter linkage, there are two ball joints either end of the thing and i want to know how to get them seperated? I was going to use brute force but thought i'd ask somebody else first. So should it come apart with a big pull or do i need some sort of tool to do it without knackering the joint?

Thanks

KarlosVTR · Post by **KarlosVTR** » Tue May 01, 2007 10:42 am

if its like the aprilia ones they should have a small clip which un clips and the rest falls free

i am open to correction btw

KarlosVTR · Post by **KarlosVTR** » Tue May 01, 2007 11:28 am

if its like the aprilia ones they should have a small clip which un clips and the rest falls free

i am open to correction btw

beesfan · Post by **beesfan** » Tue May 01, 2007 4:54 pm

It isn't like the Aprilia ones then.