high level exhaust pilion hanger spacer/bolts

General Bike chat
Post Reply
User avatar
lee67
Posts: 778
Joined: Fri Jul 27, 2007 6:48 pm
Location: south yorks

high level exhaust pilion hanger spacer/bolts

Post by lee67 »

ok, currently got carbon can co exhausts, fitted with high level link pipes by zorstec,...seen an old post about long bolts and spacers, which allow refitment of said hangers outside of the link pipes...does anyone have details on bolt length and spacer sizing etc etc....cos id really like to keep high levels fitted, whilst been able to fit pillion hangers :)
User avatar
lee67
Posts: 778
Joined: Fri Jul 27, 2007 6:48 pm
Location: south yorks

Post by lee67 »

okie dokie mike...checked usual places ebay etc, but cant find any..
User avatar
Kitch
Posts: 1548
Joined: Fri Apr 28, 2006 7:05 pm
Location: Lancashire

Post by Kitch »

I'm making some for my MIGs

Longer bolts, couple of nuts, some washers and some tubing and a hacksaw. Job done.

Yours will liekly be different to Scorpion ones. MIGs are very under the seat, so only use 1 inch or so. Remus ones are like 3 inch long.
Voted most likely to be found dead in park bushes following an act of autoerotic asphyxiation.
User avatar
RedStormV
Posts: 1372
Joined: Thu Jun 07, 2007 9:41 pm
Location: West Yorks (Bronte Country) - Home of the Negro Lesbian Cornet Players
Contact:

Post by RedStormV »

So are they for sale? or not?

High Level Link Pipes

Or is this another set of high level link pipes?

You've got a pretty decent bid from Snipper for them if they're the same ones.

Get 'em sold!

:lol:
Image
User avatar
lee67
Posts: 778
Joined: Fri Jul 27, 2007 6:48 pm
Location: south yorks

Post by lee67 »

well graeme, i took em off..to refit low level link pipes, so our lass could go on....and to be honest it looks crap low level....looked the dogs when high..so if there is a small chance i can refit em high, with the use of spacers..then i will...but if not..snipper will get em m8... :wink: kitch, i am thinking of doing exactly what your doing, cos it aint hard really....but my spacers need to be 3-4" or so 8O
User avatar
RedStormV
Posts: 1372
Joined: Thu Jun 07, 2007 9:41 pm
Location: West Yorks (Bronte Country) - Home of the Negro Lesbian Cornet Players
Contact:

Post by RedStormV »

:roll: :wink:
snipper
Posts: 156
Joined: Thu May 10, 2007 10:42 pm
Location: east yorks ....hull

Post by snipper »

go low level ...... it will go faster :wink:
Post Reply