new high levels...just for timbo

lee67 · Post by **lee67** » Fri Feb 22, 2008 4:52 pm

managed to fit em this aft'......tim aka timbo thanks alot m8, nice to finally meet you!!...they look the dogs danglies!!
[img=http://img261.imageshack.us/img261/1041/storming0002nj0.th.jpg]

Post by **sirch345** » Fri Feb 22, 2008 5:18 pm

Nice one Lee, they're looking good

Chris.

Beamish · Post by **Beamish** » Fri Feb 22, 2008 5:28 pm

Looking good Lee, makes a big difference, an essential mod.

lee67 · Post by **lee67** » Fri Feb 22, 2008 5:40 pm

bike had high levels when i got bike, 5 months ago..but you couldnt use pillion pegs with em..so sold em on...these scorpion ones come with pillion hanger spacers, will fit em when wife well enough to go back on..

lee67 · Post by **lee67** » Fri Feb 22, 2008 5:50 pm

lol mike, nah they stopping on m8...got one of those long bolts this aft, just got to get spacer made..and i know someone with a lathe wooooooooo...but will only fit as and when sue on back

..just gonna order a slightly bigger plate, then im sorted, bar renthals mod..oh and a cc bellypan/lowers

Jbrebel · Post by **Jbrebel** » Fri Feb 22, 2008 6:11 pm

Nice one Lee

Like the bag rack

Are you leaving the flush mounts in as well as the micro indicators?

lee67 · Post by **lee67** » Fri Feb 22, 2008 8:58 pm

rack is for sue to hold on to'....flush mounts are going, when i fit my number boards...and i,ll ditch micro's..cos im gonna fit r6 indi's

Jbrebel · Post by **Jbrebel** » Fri Feb 22, 2008 9:16 pm

Sounds like a plan!

Look forward to seeing the results

lee67 · Post by **lee67** » Fri Feb 22, 2008 9:19 pm

FirestormMike wrote:You missed a set of lowers on eby last week, no-one bid on them

i looked when u said sunday mike, i couldnt find em...just my luck

fishface · Post by **fishface** » Sat Feb 23, 2008 6:26 pm

looking good lee

Post by **sirch345** » Sat Feb 23, 2008 6:41 pm

lee67 wrote:
FirestormMike wrote:You missed a set of lowers on eby last week, no-one bid on them
i looked when u said sunday mike, i couldnt find em...just my luck

I had my eye on a set of lowers myself, if they were the same ones as Mike was on about they got pulled from the auction getting near to the closing stages, which was bl%dy annoying

Chris.

LotusSevenMan · Post by **LotusSevenMan** » Sat Feb 23, 2008 7:52 pm

Shall I tell you why I think these look good?
IMHO it is because the run parallel with the rear wrap around seat bodywork panel so to me they 'looks right'. When I see pipes/cans running at different angles to that bodywork it just offends my natural eye for asthetics.

Good job Lee!!!!!

lee67 · Post by **lee67** » Sun Feb 24, 2008 9:19 am

cheers lsm