Aftermarket Indicators/Alarm Wiring
Aftermarket Indicators/Alarm Wiring
I want to fit mini front & rear indicators on my VTR. I have a Datatool System 3 alarm, which seems to have wires soldered to the bulb holder in each indicator. Should I unsolder these to remove the OE indicators, then re-solder the wires to the bulb holders in the new indicators. I've only soldered once before, but if I'm told the above is the way to go, I'm confident I can do it. Anyone done it before? Comments?
94 Corolla and a big goo for an R1150GS
-
Pete.L
- Forum Health And Safety Officer
- Posts: 7305
- Joined: Fri Sep 26, 2003 5:09 pm
- Location: Bristol
Hi Silvtr
From your discription what your saying makes scence. Here's a little tip if you haven't done much soldering before.
Snip the outer insulating cable back so you can see a nice clean shiney bit of wire. The solder will flow much easier on clean surfaces
Good luck and try not to burn your fingers too much
Pete.l
From your discription what your saying makes scence. Here's a little tip if you haven't done much soldering before.
Snip the outer insulating cable back so you can see a nice clean shiney bit of wire. The solder will flow much easier on clean surfaces
Good luck and
try not to burn your fingers too much Pete.l