VTR1000.ORG

practice makes perfect buddy, my early attempts were 4 or 5 out of 10 but now i'm nearer 7 to 8....

im just being very critical to myself
steve

Fitted Titanium bleed nipple to brembo master, and also tygon clear pipe between master and reservoir.
15 whole minutes work.
I need a new project...

tried beating 12 shades of sh1t out of the generator cap so i can fit my god damn ccts. alas, it didnt move.

i think im going to need to get medievil on its wombles bitch ass

KarlosVTR wrote:tried beating 12 shades of sh1t out of the generator cap so i can fit my god damn ccts. alas, it didnt move.

i think im going to need to get medievil on its ferking bitch ass

have you tried hammering a slightly bigger torx bit into it,most times it works?
steve

havent got one and the hole is near perfectly round.

im gonna have to chop it out

Have a search for drifting it round & out, and the right place to apply the hammer.

tried it all. smacking the living snot out of it last night just didnt do a god damn thing. i think someone has tightened it right down in its life and its done its business now and stuck.

i shall swap the crap rubber o ring with a nice viton one to stop any oil & rubber related swelling so that will help no end

KarlosVTR wrote:tried it all. smacking the living snot out of it last night just didnt do a god damn thing. i think someone has tightened it right down in its life and its done its business now and stuck.

i shall swap the crap rubber o ring with a nice viton one to stop any oil & rubber related swelling so that will help no end

If you can get hold of a dremel or similar, cut a slot like a screwdriver head into it, then use an old chisel to turn it. Or....drill a 2 or 3 mm hole near the edge ( dont go right through, just a couple of mm deep will do ) then you can knock it round with a hammer and punch.

yep done that too. smacked the living hell out of it too. didnt budge

KarlosVTR wrote:yep done that too. smacked the living hell out of it too. didnt budge

I feel embarressed that mine came out first turn of the allen key

funny that. i feel enraged that yours did that

I probably should apologise....but I won't

Good luck with the dremel

(I'm saying all this now, but I bet you all they won't wombles budge when I get home and start doing the job )

oh i do hope not hahaha

id love to see it suffer your wrath. but please dont tell me that you ended up just gently whispering at it and it undone itself for you

Me too lol

If that happens I'll be known as the Storm whisperer