Page 2 of 2
Re: R1 tailed streetfighter project
Posted: Wed Apr 18, 2012 10:29 pm
by motostorm
looks good nice position with the seat unit
i played around with the fork position in the yoke a bit with , my own r1 front end , im happy with where its set now , ill measure where it ended up if any use to ya
Re: R1 tailed streetfighter project
Posted: Thu Apr 19, 2012 6:00 am
by stormsmasher
Hahaha
I need to pull my finger out, I have fitted most of the electrics just need to make an exhaust and find a smaller battery.
You can't rush these things
Daz
Re: R1 tailed streetfighter project
Posted: Thu Apr 19, 2012 10:29 am
by sirch345
stormsmasher wrote:Hahaha
I need to pull my finger out, I have fitted most of the electrics just need to make an exhaust and find a smaller battery.
You can't rush these things
Daz
Well done Daz, at least you're getting there
Chris.
Re: R1 tailed streetfighter project
Posted: Thu Apr 19, 2012 5:31 pm
by Vtrkidda
Nice job
looks factory fit wheres thek battery fitted
Re: R1 tailed streetfighter project
Posted: Thu Apr 19, 2012 5:51 pm
by stormsmasher
I intend to fit the battery in the same place a standard R1. I have to fit a smaller since the conversion eats into the standard space.
Daz
Re: R1 tailed streetfighter project
Posted: Thu Apr 19, 2012 11:16 pm
by tony.mon
I had the same problem with a little 250 cafe racer a while ago; I fitted two tiny ones in parallel to give me enough current.
Several years ago I used two six-volt batts in series when I did a 12 volt conversion on a six volt bike.