Page 1269 of 1529
Re: what have you done to your "bike" today
Posted: Tue Aug 06, 2019 10:06 pm
by Beef
Bit of prep for Fridays visit to PDQ:
Fitted another rear velocity stack to front cylinder, added filter to the lid, I was going to check my needles but it was too dark in my shed
Re: what have you done to your "bike" today
Posted: Thu Aug 08, 2019 12:54 am
by mik_str
Beef wrote: ↑Tue Aug 06, 2019 10:06 pm
Bit of prep for Fridays visit to PDQ:
Fitted another rear velocity stack to front cylinder, added filter to the lid, I was going to check my needles but it was too dark in my shed
she`ll flow now!
Re: what have you done to your "bike" today
Posted: Sat Aug 10, 2019 11:43 pm
by Beef
It did flow.....too well that the carbs didn’t like it!
Re: what have you done to your "bike" today
Posted: Sun Aug 11, 2019 1:35 am
by mik_str
Beef wrote: ↑Sat Aug 10, 2019 11:43 pm
It did flow.....too well that the carbs didn’t like it!
It`s all about tuning; I have been running this set-up for a few years now and, while it took time to get it sorted, it runs perfectly well now (no burbles or flat sports anywhere and it pulls like a banshee regardless of rpm).
Re: what have you done to your "bike" today
Posted: Sun Aug 11, 2019 4:26 pm
by freeridenick
I took the VFR out for a quick spin yesterday and it was horrible into turns. A quick check of the head bearings this morning and it's notchy off the center position. Might have to replace the bearings before I head to Austria on it.
Re: what have you done to your "bike" today
Posted: Sun Aug 11, 2019 8:53 pm
by MacV2
Custard got a new indi bulb, kicked the tyres & checked the oil...
Later in the day did a C&S swop on Numpty Kirons CB125...
New chain had a split link not rivets. The old one possibly the origonal was hanging off the sprocket it was so worn.
Cut it off with bolt croppers...
Strange fixing on the front sprocket, two small bolts holding a plate to the sprocket which sits in a groove in the spline, still has loads of play in it when on...
Re: what have you done to your "bike" today
Posted: Mon Aug 12, 2019 11:56 am
by thelens
Booked it in at bike tech again grrrrr
Seems head bearings are loose. Bike shakes it’s head when letting go of the bars. So have booked it in. Hopefully they have just gone slack but new head bearings otherwise. While it’s in.... full service with all fluids changed and a one tooth larger rear sprocket fitted.
The bill will be interesting
worse thing.... 3 weeks before they can fit in
Re: what have you done to your "bike" today
Posted: Mon Aug 12, 2019 1:48 pm
by tony.mon
MacV2 wrote: ↑Sun Aug 11, 2019 8:53 pm
Custard got a new indi bulb, kicked the tyres & checked the oil...
Later in the day did a C&S swop on Numpty Kirons CB125...
New chain had a split link not rivets. The old one possibly the origonal was hanging off the sprocket it was so worn.
Cut it off with bolt croppers...
Strange fixing on the front sprocket, two small bolts holding a plate to the sprocket which sits in a groove in the spline, still has loads of play in it when on...
Thats a standard fitment for smaller Honda's, the small plate has spline cutouts out of alignment with the splines when bolted onto the sprocket, so it can't come off.
The sprocket can also self-align. Looks bad but works well enough.
Re: what have you done to your "bike" today
Posted: Mon Aug 12, 2019 3:09 pm
by Beef
mik_str wrote: ↑Sun Aug 11, 2019 1:35 am
Beef wrote: ↑Sat Aug 10, 2019 11:43 pm
It did flow.....too well that the carbs didn’t like it!
It`s all about tuning; I have been running this set-up for a few years now and, while it took time to get it sorted, it runs perfectly well now (no burbles or flat sports anywhere and it pulls like a banshee regardless of rpm).
I am sure it would be good but as I had running issues anyway, I thought that getting the bike running right without spending a fortune on dyno time was my best option. (I an up to my neck in house renovations so get very little time for fun stuff) I wanted to get the bike right for Cadwell Pk in Sept!
It's sorted now
Re: what have you done to your "bike" today
Posted: Mon Aug 12, 2019 8:59 pm
by freeridenick
Beef wrote: ↑Mon Aug 12, 2019 3:09 pm
I wanted to get the bike right for Cadwell Pk in Sept!
It's sorted now
Ah! It's you. I knew there was someone else going. PS weekend job right?
Re: what have you done to your "bike" today
Posted: Mon Aug 12, 2019 9:43 pm
by fabiostar
Re: what have you done to your "bike" today
Posted: Mon Aug 12, 2019 9:50 pm
by sirch345
Re: what have you done to your "bike" today
Posted: Mon Aug 12, 2019 10:01 pm
by fabiostar
cheers Chris, its been a fight but i was so far down this road i had to get a result
Re: what have you done to your "bike" today
Posted: Tue Aug 13, 2019 9:30 am
by fabiostar
Re: what have you done to your "bike" today
Posted: Tue Aug 13, 2019 2:33 pm
by Beef
freeridenick wrote: ↑Mon Aug 12, 2019 8:59 pm
Beef wrote: ↑Mon Aug 12, 2019 3:09 pm
I wanted to get the bike right for Cadwell Pk in Sept!
It's sorted now
Ah! It's you. I knew there was someone else going. PS weekend job right?
Yup, you got it 15 & 15 Sept
Be good to meet you
