VTR1000.ORG

Hi all
Nudder newbie here in de west of Oirland. Just traded in a briefly-owned 98 35k job for an 01 16k. Ting is the 98 had Microns, so am gonna do a bafflectomy on the 01. I wonder has anyone penetrated beyond the rear baffle, that is, without sawing the end off the can? (I've seen those pics from the American cousin's site) What I had in mind was somehow interfering with the next set of baffles...

hail and farewell

Welcome, I too have never bothered with the std cans

Welcome aboard scoffey

I have a feeling you will need to cut the end off to remove the next set off baffle's, but I could be wrong

Chris.

Arrr...Welcome young man.You'll find a lot of good info on this site,and there a friendly bunch too. If your looking for info on baffles "or the lack of" go to bike chat page 3 scroll down to baffles just drilling or out altogether..thats a place to start..hope its helps.

cheers Chris C.

welcome in matey, just buy some more micron's ya tight get

Would do dat, only I'm hoarding dosh in order to trade my curvy SV for a 749

Hi mate,
i removed the rear baffle on mine, but never touched the inner ones CLICK--- http://www.vtr1000.org/phpBB3/viewtopic ... ns#p105412 ,but i do remember someone on this forum telling me they used a long sharp steel bar , sharpened to a point, to burst a hole in the inner baffle plate

Heres a pic of what you see when the outer rear baffle is removed ,its not normally visible , really only seen with the camera flash.

Welcome

Go steady with the drill

Tanx everyone for all dat
Have bafflectomied and am now considering further penetration