got some flush mounted powerbronze indicators at the show last weekend. Flash rate is about 120 fpm. Checked the wattage of the bulb and shows same as standard????? What gives? I thought only Led's needed a resister? Put the Honda bricks back on and the flash rate is fine?
Anyone any thoughts
Non Led indicators flash too fast
Non Led indicators flash too fast
V8 on 4 wheels V2 on 2
Ahhh! My favorite subject...... not! Have just fitted some Hein Gericke flush indicators (probably came from the same factory) and had the same problem. Spoke to them and they left me none the wiser. I reckon it might be that the new bulbs are much more efficient than the 5 year old rectifier thingy in my bike. Put some led type resistor things on (about £5 on ebay) and Robert's you're father's brother as they say!!
Hope this helps!
PS. Mine weren't LEDs either!
PPS. That was on an SP!
Hope this helps!
PS. Mine weren't LEDs either!
PPS. That was on an SP!
Last edited by Seeker 77 on Wed Nov 09, 2005 8:00 pm, edited 1 time in total.
- firestorm_al
- Site Admin
- Posts: 754
- Joined: Mon May 20, 2002 9:56 am
- Location: Aberdeen (Scotland - UK)
- Contact:
- monomaster
- Posts: 71
- Joined: Wed May 11, 2005 1:47 am
- Location: Sydney, Australia
- Contact:
- Squiffythewombat
- Posts: 1406
- Joined: Sun Apr 17, 2005 1:51 pm
- Location: Canterbury, Kent
- Contact:
- firestorm_al
- Site Admin
- Posts: 754
- Joined: Mon May 20, 2002 9:56 am
- Location: Aberdeen (Scotland - UK)
- Contact:
.... or try one of these - http://cgi.ebay.co.uk/Electronic-Flashe ... dZViewItem