VTR1000.ORG

Cheers for that will lube if needed and will do the disc thingee, clean up etc as in one of the other subjects

Call me stupid but you say the slid pin got a pic of said slide pin?

Sweet as, for that, will look into it, can't have all that power being held back

Hi Guys hope someone may be able to shread some light on this, Rode the bike today and noticed that the rear brake feels like it is dragging, when you push down on the foot brake it feels real firm and you don,t have to push far for it to lock, plus the rear disc was extremely hot, any tips

Cheers, had no problem with it before so why fix something that works well

Just wanting to know, when i put my bike bike together from doing the CCt's i noticed that i am only using one throttle cable, is that alright or should i have two there, it has the second outer there for it?

Well i did post earlier but have now edited it cos i got it sorted. It Starts runs sounds good, :Beer1: just got the rest of the fairing to put back on and all done, is there anything to watch out for now that the manuals are in, i have used thread lokka on the manuals so hopefully they stay put wil...

Geez just had my heart in my throat, putting the small 10mm bolt back on the side of the cam chain cover thingee and i dropped it :sad2 , was on a mission to find a touch to see if i could see it, it was on the front cylinder which might of been a bit of luck on my side, so i shined the torch down t...

Well got the cct's replace with manual ones, Then the wifes uncle suggest we check the valve clearances will we are at it, so will be doing that next week once i get some feeler gauges, got the chain adjusted to 5-7 mm slack as per instructions and hand turned it over and all is well as can be,

Cheers Hairy biker, is there a some where in here that has like all the torque settings as well

Hi Guys, just wanting to know what the torque settings are for the cam chain guide, is there a sheet on here that has all torque settings

Cheers for the reply, i might leave it cause the cam lobs seam to be pointing at the same mark say bolt or point on a bolt so we will see

Well just about half way through, this but went to check my cam RI and RE it looks like the RE is a little lower than the RI marking, now does that mean it may have slipped a tooth and if so should i move it back that 1 or 2 teeth how many it takes to line up, just wanted to share and get some exper...

cheers guys was a good day

All good now how a real good look and found it, i was pushing that the first time but nothing was happening but that was my fat fingers not engaging it properly so crisis adverted thanks anyway