size of nut ???? help

[dodds]

I need to get a socket to fit the swing arm spindle nut ( left side, not bolt end) but not sure of size , 26mm ??? anyone help.

[delmeekc]

err. thinks it's 30 but not sure, can check tonight or firestorm996 will know as he had his off (oh err) a few days ago.

Del.

[t00lkit]

Can't find the size of the nut, kids have moved my cd-rom, but according to the book the torque setting needs to be 93N-m / 69lb-ft when putting back together.

Please check this when removing, I hate you to tighten it too much

t00lkit

[RQ]

Have the manual on the system at work, not sure which one you are on about but here are a few choices !
Rear Axle 18mm
Final Drive Sprocket nut 12mm
Shock Upper mounting 10mm
Shock Lower 10mm
Shock to swing 10mm
Swing arm pivot nut 18mm
Nothing in the "Rear Wheel / Suspension" section bigger than 18mm
If it's none of these send me your mail address and I'll send the page of sizes as an attachment.

[dodds]

And the winner is 27mm. Apparently they vary from bike to bike. i knew i would catch you out one day del .

[delmeekc]

I always go abit bigger

but dya have two big rachets/t-bars to hold both ends of the bolt, can't use a spanner. If your taking it off then loosen it before you put the bike on a lifting stand, saves pulling the bike off d stand whilst ya popping blueies out ya arms.

Del. (wots 3mm between friends ehh)