Anudder One

[scoffey]

Hi all
Nudder newbie here in de west of Oirland. Just traded in a briefly-owned 98 35k job for an 01 16k. Ting is the 98 had Microns, so am gonna do a bafflectomy on the 01. I wonder has anyone penetrated beyond the rear baffle, that is, without sawing the end off the can? (I've seen those pics from the American cousin's site) What I had in mind was somehow interfering with the next set of baffles...

hail and farewell

[Beamish]

Welcome, I too have never bothered with the std cans

[sirch345]

Welcome aboard scoffey

I have a feeling you will need to cut the end off to remove the next set off baffle's, but I could be wrong

Chris.

[ChrisC]

Arrr...Welcome young man.You'll find a lot of good info on this site,and there a friendly bunch too. If your looking for info on baffles "or the lack of" go to bike chat page 3 scroll down to baffles just drilling or out altogether..thats a place to start..hope its helps.

cheers Chris C.

[marravtr]

welcome in matey, just buy some more micron's ya tight get

[scoffey]

Would do dat, only I'm hoarding dosh in order to trade my curvy SV for a 749

[bikerpiker]

Hi mate,
i removed the rear baffle on mine, but never touched the inner ones CLICK--- http://www.vtr1000.org/phpBB3/viewtopic ... ns#p105412 ,but i do remember someone on this forum telling me they used a long sharp steel bar , sharpened to a point, to burst a hole in the inner baffle plate

Heres a pic of what you see when the outer rear baffle is removed ,its not normally visible , really only seen with the camera flash.

[Jbrebel]

Welcome

Go steady with the drill

[scoffey]

Tanx everyone for all dat
Have bafflectomied and am now considering further penetration