Just wanted to ask who is using these type kits with lighter slide springs so you do not have to make a permanent hole in your slides .
What is your final main jetting and needle clip height ?
And what other mods to include air filters
Factory Pro Jet Kits
-
4bangthis996
- Posts: 38
- Joined: Mon Nov 24, 2003 6:07 am
- Location: Orlando, Florida. the shity states
i have the springs and the hole cut in my slide. cutting the hole is worth it. and its not hard if you get the brace of metal that slides over the top of the slide with a hole in it. everything lines up perfectly. im using a 185front 190 rear. mixture screw turne 2 3/4 turns out from all the way in. needle groove set on 5 from the top. im probably going to go to 6th from the top which is all the way down. on the dyno my air fuel is a 13.2 which is perfect. but also remember im in florida where the highest elevation where im at is probably a parking garage deck.
Adeptus Mechanicus