![Image](https://fbcdn-sphotos-a-a.akamaihd.net/hphotos-ak-xaf1/v/t1.0-9/10154558_10152788818880856_5062168049515035046_n.jpg?oh=4c53a15b45e16982923dec42f2026c80&oe=54D8487F&__gda__=1420641995_3ad3c698896c0e56682c2d529437bb06)
To weld a washer onto that sprocket shaft what welder / wire or rod would i require?
if i was to get an Arc welder what type of rod would i need?
Is a mig better suited to this? how thick should the wire be?
never welded before but cannot use the bike due to the shaft being wombles as some previous wonker used the bike with no circlip so now it wont stay in place as the shaft end is knurled off
tried to tap it as the hole was 8.5mm so tried to M10 Tap it, man that sprocket shaft is made of some hard sh1t!! taps wouldn't even wombles make a scratch on it
Washer i would be trying to spot weld onto it would be an M10 one of these
http://www.ebay.co.uk/itm/121233245645? ... EBIDX%3AIT