what have you done to your "bike" today
- bigtwinthing
- Posts: 5577
- Joined: Mon Dec 17, 2012 7:52 pm
- Location: Hampshire
Re: what have you done to your "bike" today
266 miles, with the Missus checking for France. Weathers looking good can't wait.
missing the noise, not the vibes. However never say never!
Re: what have you done to your "bike" today
Some good going there chaps...falling off them does keep the mileage down thou eh Mac?
..and I also have the trip meter showing on my bike constantly too!

..and I also have the trip meter showing on my bike constantly too!
- bigtwinthing
- Posts: 5577
- Joined: Mon Dec 17, 2012 7:52 pm
- Location: Hampshire
Re: what have you done to your "bike" today
Portland and back today, cranking it up a bit. It does tramp on, seriously comfy and a superb view along the road. had a blast with a guy on a fixer 750 from dorchester to ringwood.
missing the noise, not the vibes. However never say never!
- agentpineapple
- Posts: 15124
- Joined: Sat Mar 26, 2011 9:16 pm
Re: what have you done to your "bike" today
I had a spirited if cold and wet 100 ride in the rain this evening.
as some might remember, many years ago I bought some dan moto bar risers, and they we're awful, because of this, I've not knowingly purchased anything from china. of course there's always the chance that the part you buy is originating there with out you knowing it.
but recently my left leg has been giving me issues on the bike, and i'm unable to move my left foot when it comes to cornering, hence my toe slider is taking a bashing.
so I bit the bullet and looked to solve the issue using a pair of adjustable footpegs from china, if they work well, and it looks like they'll be spot on. I might spend the extra and get a set from the uk, but lets see how these hold up first, they're a 25mm drop, and you can adjust the pedal abgle in 45 degree increments.
after 100 miles i'm impressed, no issues with vibes, I can move my feet easily.
seen as I've started with the pegs being 25mm lower and 45 degree's forward. i'm impressed, I might adjust them with out the 45 degree's forwards and see how that feels.

http://www.ebay.co.uk/itm/292039061615? ... EBIDX%3AIT
as some might remember, many years ago I bought some dan moto bar risers, and they we're awful, because of this, I've not knowingly purchased anything from china. of course there's always the chance that the part you buy is originating there with out you knowing it.
but recently my left leg has been giving me issues on the bike, and i'm unable to move my left foot when it comes to cornering, hence my toe slider is taking a bashing.
so I bit the bullet and looked to solve the issue using a pair of adjustable footpegs from china, if they work well, and it looks like they'll be spot on. I might spend the extra and get a set from the uk, but lets see how these hold up first, they're a 25mm drop, and you can adjust the pedal abgle in 45 degree increments.
after 100 miles i'm impressed, no issues with vibes, I can move my feet easily.
seen as I've started with the pegs being 25mm lower and 45 degree's forward. i'm impressed, I might adjust them with out the 45 degree's forwards and see how that feels.

http://www.ebay.co.uk/itm/292039061615? ... EBIDX%3AIT
HEY YOU GUYS!!!!!!
Re: what have you done to someone else's"bike" today
Saturday round 4 on the Vanstub engine replacement saga...
Checked the valve clearences then introduced the frame to the lump...They said hello but dind't bond very well as the top front engine bolt turned out to be a rear bottom one...So a quick call or four later we headed over to Tony's to pick up the emergency lenght of SS studing to use as an emergency replacement...It was then indserted with plenty of grease & a hand crafted spacer...so all is good for now...
So if anyone happens to have a genuine top front engine mount bolt c/w the spacer for the left hand side, the nut & adjuster doh dah they want to part with Mr Vanstub would be most gratefull...
So all bolts heavily greased up & tightened...
Boxed up & put to bed...Then we watched The superbike race 1...
Checked the valve clearences then introduced the frame to the lump...They said hello but dind't bond very well as the top front engine bolt turned out to be a rear bottom one...So a quick call or four later we headed over to Tony's to pick up the emergency lenght of SS studing to use as an emergency replacement...It was then indserted with plenty of grease & a hand crafted spacer...so all is good for now...
So if anyone happens to have a genuine top front engine mount bolt c/w the spacer for the left hand side, the nut & adjuster doh dah they want to part with Mr Vanstub would be most gratefull...
So all bolts heavily greased up & tightened...
Boxed up & put to bed...Then we watched The superbike race 1...

Making up since 2007, sometimes it's true...Honest...
Re: what have you done to someone else's"bike" today
Due to my speed-reading and short attention span, this read:
Lucky he didn't bolt.MacV2 wrote: Vanstub engine replacement saga...
Checked introduced dind't bond very well
rear bottom one...So a quick emergency lenght...It was then indserted with plenty of grease & hand crafted
So Mr Vantub most gratefull...
So heavily greased up & tightened... & put to bed...Then we watched The superbike race 1...
It's not falling off, it's an upgrade opportunity.
Re: what have you done to someone else's"bike" today
tony.mon wrote:Due to my speed-reading and short attention span, this read:Lucky he didn't bolt.MacV2 wrote: Vanstub engine replacement saga...
Checked introduced dind't bond very well
rear bottom one...So a quick emergency lenght...It was then indserted with plenty of grease & hand crafted
So Mr Vantub most gratefull...
So heavily greased up & tightened... & put to bed...Then we watched The superbike race 1...

Making up since 2007, sometimes it's true...Honest...
- bigtwinthing
- Posts: 5577
- Joined: Mon Dec 17, 2012 7:52 pm
- Location: Hampshire
Re: what have you done to your "bike" today
packed the panniers and the top box and tank bag. Off at 0600 tomorrow Yahoo.
missing the noise, not the vibes. However never say never!
Re: what have you done to your "bike" today
Have a safe and enjoyable time Paul,bigtwinthing wrote:packed the panniers and the top box and tank bag. Off at 0600 tomorrow Yahoo.
Chris.
- bigtwinthing
- Posts: 5577
- Joined: Mon Dec 17, 2012 7:52 pm
- Location: Hampshire
Re: what have you done to your "bike" today
sirch345 wrote:Have a safe and enjoyable time Paul,bigtwinthing wrote:packed the panniers and the top box and tank bag. Off at 0600 tomorrow Yahoo.
Chris.
Cornwall in July, I owe you a beer, lets get sorted this Year Chris.
missing the noise, not the vibes. However never say never!
Re: what have you done to your "bike" today
Got the big girl ready for mot on Tuesday
New rear indicators
New lamps for the clocks
Going to fit cbr brakes after I get here passed
New rear indicators
New lamps for the clocks
Going to fit cbr brakes after I get here passed
told you not to but oh no you knew better
- Pete.L
- Forum Health And Safety Officer
- Posts: 7305
- Joined: Fri Sep 26, 2003 5:09 pm
- Location: Bristol
Re: what have you done to your "bike" today
Got my MOT on the SP today.
Thought I might get some stick about the rear tyre but I got away with just an advisory
New tyre to be sorted ASAP.Just bad timing and laziness on my part to be honest
Thought I might get some stick about the rear tyre but I got away with just an advisory

New tyre to be sorted ASAP.Just bad timing and laziness on my part to be honest

My new ride is a bit of a Howler and I love to make her Squeal
Re: what have you done to your "bike" today
Set off at 6.30am to sunny Oxford to pick up my ebay collection only purchase. Took the tranny for the comfort, tank range & fuel economy (only one fuel stop on the 300 mile round trip). All went well apart from hitting the M25 stop-start rushhour on the way up. Next time I'll get up earlier or better still not be daft to buy stuff so far away!
It may be that your whole purpose in life is simply to serve as a warning to others.
VTR Firestorm and other bikes t-shirts

Re: what have you done to your "bike" today
Well! How did it go??macdee wrote:Got the big girl ready for mot on Tuesday
New rear indicators
New lamps for the clocks
Going to fit cbr brakes after I get here passed
SH#T HAPPENS!!!!!!!!
Re: what have you done to your "bike" today
took the long way home from work. like an extra 80 miles.
...

the older i get,the faster i was 
