Well today I got out and washed the bike. It needed it after sitting through winter. Getting myself prepared to get it all back together and as soon as proper warm weather arrives I can get the spray cans back out. In the meantime I can do some other bits like get the rear end back together. I also need to work out the sizing and angles for some exhaust madrels for swept up link pipes. I might have to go with something like
this and then add a short straight bit on. The hard part is going to be able to work out the angles. Any advice Varastorm?

Iv'e got some nice Carbon Scorpians to go on but the links with them are low levels and also the outlets on my race header are not at a standard angle. Ideally I would like some swept up mid level links where I can swap cans at will if I want to throw on some diffrent cans. Othe stuff to do is fit an undertray, sort out the tail tidy with new plate, fit led indicater rear and front. Fit the Oberon slave and bleed clutch and brakes, fit fork brace. Stick some Carbon engine protectors on, spray panels, fit decals, lacquer, I'm sure there's other stuff but I can't think what.
I'm fed up with the bike getting wet and covered in shite from the tree's when sitting doing nothing so I then went and ordered an
Oxford Protex Stretch Outdoor Bike Cover I could not decide between a medium or large but decided on medium size in the end. I also ordered an
Oxford Solariser Optimiser at the same time. Thought it may be useful.
Right....bring on the sunshine. Let's get this bike back on the road.