Just added up the fule recipits...£113.14...77.73 ltrs...

Is that correct Mac ?MacV2 wrote:Cleaning Nue Red of Wales can wait till later...
Just added up the fule recipits...£113.14...77.73 ltrs...
Well unless I missed a recipit out thats what it added up to...Duffy1964 wrote: ↑Mon Sep 12, 2022 1:58 pmIs that correct Mac ?MacV2 wrote:Cleaning Nue Red of Wales can wait till later...
Just added up the fule recipits...£113.14...77.73 ltrs...
I spent £144.61 on 80.9 litres
That average is £1.77 per litre
Working out to 40.3 mpg
Sent from my iPhone using Tapatalk
I may not have saved any fuel cost using the van to get me there and back, but I certainly saved expensive bike tyres!
Absolutely! The motorway chewed my rear tyre to bits last year. That gets expensive quicklytony.mon wrote:I may not have saved any fuel cost using the van to get me there and back, but I certainly saved expensive bike tyres!
A night out on the bike with James ..... What could be be better
proper sh1ts and giggles all night on our fav roads round here, the tyres are well scrubbed in
At last got round to sorting the issue above as bike has not been used, @sirc345 was spot on overtight!!! Cam chains cam covers off, tensioner guide off timing marks set and slacked of manual adjusters to get 7-8mm chain slack.sirch345 wrote: ↑Mon Mar 21, 2022 9:49 pmI would suggest backing out the adjuster on one cylinder first one or two flats, if you were able to tell which cylinder you heard the screech from then do that one first. You want to do that when the of engine is stone cold, so if the first cylinder you go for doesn't cure the screech try the other one the next day so the engine is cold. Good luck,mjvw wrote: ↑Mon Mar 21, 2022 9:05 pm Locked 0EM off using lock of key rear first TDC then front TDC measured and set manual ls up to that setting checked motor turned ok no issues.
As per instructions provided with purchased ccts and site instruction but did not measure chain slack.
Was hoping could back them off without removing cam cover as all new gaskets and cam bolt washers fitted.
Thanks for the help.
![]()
Chris.