VTR1000.ORG

You were lucky to get away without a blow out Macster

Duffy1964 wrote:You were lucky to get away without a blow out Macster

Must try harder

fitted over sized pistons and balanced carbs bringing it to about 180bhp

chric wrote:fitted over sized pistons and balanced carbs bringing it to about 180bhp

What you smoking mate

Another delusional red owner Watty. One day they'll learn!!!

Kev L wrote:Another delusional red owner Watty. One day they'll learn!!!

They slow to learn, then again, red owners

chric wrote:fitted over sized pistons and balanced carbs bringing it to about 180bhp

I polished the ports aswell makes oil glide through them better in mid range
fitted new titanium bolts saves weight and can keep eating more chips to balance it out.
And fitted nitrous for when i do bit of street raceing tops out about 190mph now





















come on sounds better than i waxed it

Wicky wrote:

chric wrote:fitted over sized pistons and balanced carbs bringing it to about 180bhp

Oh hello

chric wrote:I polished the ports aswell makes oil glide through them better in mid range
fitted new titanium bolts saves weight and can keep eating more chips to balance it out.
And fitted nitrous for when i do bit of street raceing tops out about 190mph now





















come on sounds better than i waxed it

Suppose it does mate

here's a few more lovely ladies for you to ogle......

agentpineapple wrote:here's a few more lovely ladies for you to ogle......

Oh yeah

Marty if the one on the left is your idea of a lovely lady...it explains your poor taste in bike colours...





Oh hang on what's that she's sitting on...


Is that the only pic you could find of lady's sitting on a blue Storm... ?

I did a little tinkering today, ultrasonically cleaned a pair of oem front brake disc's, also my givi rack was looking tatty, so I stripped the paint off, down to the bare metal, cleaned it up, etch primed it and started to give it a coat of hammerite satin black, I forgot what a pain it is to use hammerite.
but done properly the finish is very good, I also re-lacquered a pair of mirrors that have been hydro dipped in carbon effect.
I 've also been struggling to try and drill out a couple of stubborn bolts, even using dewalt extreme drill bits and moly slip, I can't get the buggers out, I might have to take them to a garage to get them removed....

I 've also been struggling to try and drill out a couple of stubborn bolts

Which bolts is that mate?

(:-})