VTR1000.ORG

agentpineapple wrote:you'll be able to investigate the devon shrubbery at greater speed.......

I'll remember the berries next time :-)
Picked up the correct clutch push rod oil seal today as the one they gave me was for the clutch slave cylinder .
I hope to make some more progress tomorrow :-)

today, well yesterday I started cleaning up my spare (rusty) oil pipes ready to be painted up with my lidl dremmel.

lumpyv wrote:today, well yesterday I started cleaning up my spare (rusty) oil pipes ready to be painted up with my lidl dremmel.

Using a paintbrush will be a lot less messy

agentpineapple wrote:you'll be able to investigate the devon shrubbery at greater speed.......

i will do it slower again i expect .

Fitted the linkage bearings without a problem today, also fitted all balls bearing to the freshly painted bottom yoke

Duffy1964 wrote:Fitted the linkage bearings without a problem today, also fitted all balls bearing to the freshly painted bottom yoke

keep up the good work dude............

Won't be long now Duffy till your out riding it

I can't find lots of bits in the Duff Cave took me 2 hours to find where I put the triple clamp lock nuts

Slowly making progress though ( should have painted it red as its so slow)

It's not slow ! You are .
Have a good sort out in the cave as you never know you might find Carl trapped in a corner

lloydie wrote:It's not slow ! You are .
Have a good sort out in the cave as you never know you might find Carl trapped in a corner

I think if Carl was in there I would see the smoke

I had a play in the Duff Cave

http://www.vtr1000.org/phpBB3/viewtopic ... 39#p371439

Fixed my indicators and put the Battery on charge. I just realised my MOT is due at the end of February I shall have to give it a clean and good going over for that one this year. What's the odds on my headlight being out of alignment

(:-})

My MOT and tax is due end of Feb too, bike won't be back in one piece by then though so might have to SORN for the sake of a week or two

Nowt, but my FZS600 Fazer hugger turned up (I reckon it'll fit a TRX looking at the mounts and the fact the chainguard is the same Yamaha part number for both models, and swingarm is identical apart from chain adjusters) and it only cost £30 compared to £80 for a TRX one.....also visited Mac V2 in the principality of Grain to borrow his Abba stand, cheers Mac

Brought one of these battery's
http://pages.ebay.com/link/?nav=item.vi ... 1565281597
Wow it turns over fast now .

Took it for the MOT and it passed :-)

Just need to tax it next month and it's ready for the years antics