Re: what have you done to your "bike" today
Posted: Sat Sep 26, 2015 7:14 pm
Moved the VTR into the lounge for a winter strip down. But, such good weather went for a ride on the Yam. Will start taking things off tomorrow....
VTR1000.ORG
The UK's Number One FireStorm Website
https://www.vtr1000.org/phpBB3/
what have you done to your "bike" today
Page 928 of 1529
Re: what have you done to your "bike" today
Posted: Sat Sep 26, 2015 8:40 pm
Added some more dirt onto it . Starting to look like Tony's bike
Re: what have you done to your "bike" today
Posted: Sat Sep 26, 2015 8:43 pm
rode it with a big smile. Iam emptying my van tomorrow of my own tools etc. Just leaving the company ones. Iam gonna enjoy that.
Also my new boss has sent an e mail to all concerned that i am starting and he's sent me through a training Matrix already. Brilliant.
Out for a ride tomorrow, then the Van stuff.
Also my new boss has sent an e mail to all concerned that i am starting and he's sent me through a training Matrix already. Brilliant.
Out for a ride tomorrow, then the Van stuff.
Re: what have you done to your "bike" today
Posted: Sat Sep 26, 2015 9:17 pm
Re: what have you done to your "bike" today
Posted: Sat Sep 26, 2015 9:24 pm
It worked [THUMBS UP SIGN]
Re: what have you done to your "bike" today
Posted: Sat Sep 26, 2015 11:28 pm
Dropped two sizes on main jets, as it was running too rich on the Wales run, down to 168 rear and 165 front and it's still not right but feels lots better, and the power is back.
And the popping and banging on the overrun, I've missed that.
It's set up with both fuel screws two turns out, I need to play a bit more as they're not balanced yet, using the Flo Commander one runs a bit lean, one a bit rich, so I'll balance those, re-balance the carbs then start on the needle positions again. Nearly there...
Then I'll do a dyno power run, and see what we've got this time, with the oversize inlet valves.
And the popping and banging on the overrun, I've missed that.
It's set up with both fuel screws two turns out, I need to play a bit more as they're not balanced yet, using the Flo Commander one runs a bit lean, one a bit rich, so I'll balance those, re-balance the carbs then start on the needle positions again. Nearly there...
Then I'll do a dyno power run, and see what we've got this time, with the oversize inlet valves.
Re: what have you done to your "bike" today
Posted: Sun Sep 27, 2015 11:09 am
Oiled the chain
Now going to give her a good thrashing
Now going to give her a good thrashing
Re: what have you done to your "bike" today
Posted: Sun Sep 27, 2015 1:11 pm
Yesterday on the ride to work it was a tad cold 2'c , even though I had my winter gloves on my fingers were still cold .
So when I got to work I had a look on eBay and I found some Oxford sport bar muffs for £5 ,though tatty and well used I'd thought I'd give them a go and local collection to boot and I could pick them up on the way home , if I didn't get on with them it's no big loss .
I fitted them last night ready for the ride to work this morning .
So this morning I put on some summer gloves so I can really test the muffs out and to my surprise my hands stayed warm all the way even though it was 2'c again .
It was even easy to remove my hands to clear my visor and pop my hands back in without messing with the controls , this was what I was worried about the most but I shouldn't of ,silly really !.
So that's it I'm going to get myself a better set asap.
So when I got to work I had a look on eBay and I found some Oxford sport bar muffs for £5 ,though tatty and well used I'd thought I'd give them a go and local collection to boot and I could pick them up on the way home , if I didn't get on with them it's no big loss .
I fitted them last night ready for the ride to work this morning .
So this morning I put on some summer gloves so I can really test the muffs out and to my surprise my hands stayed warm all the way even though it was 2'c again .
It was even easy to remove my hands to clear my visor and pop my hands back in without messing with the controls , this was what I was worried about the most but I shouldn't of ,silly really !.
So that's it I'm going to get myself a better set asap.
Re: what have you done to your
Posted: Sun Sep 27, 2015 1:22 pm
What you really need is a Tartan rug for the back seat...Oh & a nodding dog* for that full on Granada look...lloydie wrote:Yesterday on the ride to work it was a tad cold 2'c , even though I had my winter gloves on my fingers were still cold .
So when I got to work I had a look on eBay and I found some Oxford sport bar muffs for £5 ,though tatty and well used I'd thought I'd give them a go and local collection to boot and I could pick them up on the way home , if I didn't get on with them it's no big loss .
I fitted them last night ready for the ride to work this morning .
So this morning I put on some summer gloves so I can really test the muffs out and to my surprise my hands stayed warm all the way even though it was 2'c again .
It was even easy to remove my hands to clear my visor and pop my hands back in without messing with the controls , this was what I was worried about the most but I shouldn't of ,silly really !.
So that's it I'm going to get myself a better set asap.
* Soz forgot you already have one of these...
Re: what have you done to your "bike" today
Posted: Sun Sep 27, 2015 1:52 pm
Ha ha I'll order some [THUMBS UP SIGN] ,
Re: what have you done to your
Posted: Mon Sep 28, 2015 2:43 am
Hey Mac, you don't spell Granddad like thatMacV2 wrote:What you really need is a Tartan rug for the back seat...Oh & a nodding dog* for that full on Granada look...
Re: what have you done to your
Posted: Mon Sep 28, 2015 5:56 am
Hey Jamie i did one of those for me mock CSE,s back in about 1974. i lobbed a melon up the school playing field. Awesome bit of kit.
i wasn't allowed to do the giant crossbow thing
Re: what have you done to your "bike" today
Posted: Wed Sep 30, 2015 2:10 pm
took arrow cans to local exhaust maker for repair. Left inner tube is slightly damaged and bottom collar as well. I am looking forward to new titanium sleeves :-)
Re: what have you done to your "bike" today
Posted: Wed Sep 30, 2015 2:11 pm
Post a few pics when you get them back :-)Stephan wrote:took arrow cans to local exhaust maker for repair. Left inner tube is slightly damaged and bottom collar as well. I am looking forward to new titanium sleeves :-)
Re: what have you done to your
Posted: Wed Sep 30, 2015 3:11 pm
will do, I hope I will finally get some actual dyno sheet during october as well :-)lloydie wrote:Post a few pics when you get them back :-)Stephan wrote:took arrow cans to local exhaust maker for repair. Left inner tube is slightly damaged and bottom collar as well. I am looking forward to new titanium sleeves :-)