VTR1000.ORG

forde wrote:They look good just what i want, keep me informed when you get them off id like to take em off your hands

Yes mate, NP - PM me your email....

forde wrote:whats the eta on the new ones?

As soon as I can get the others bent up - I need to find a local (Hants or Staffs) benders, who are prepared to bespoke abit. It'd be better if I had something they could copy, but I'm sure a pro will get it by copying the bottom bends, and reducing the angle of the top bends...

forde wrote:maybe someone on here would measure their scorpion ones or something and you could get them made up like that

Now, that would be perfect...

<Shouts> Guys...?

cliveyandrews wrote:
As soon as I can get the others bent up - I need to find a local (Hants or Staffs) benders, who are prepared to bespoke abit. It'd be better if I had something they could copy, but I'm sure a pro will get it by copying the bottom bends, and reducing the angle of the top bends...

surely all you need to do is make an exact copy of the existing link pipe but make the last bit of pipe longer where the cans go on? leave all the bends the same just lengthen the top straight part?

any performance exhaust places could do it

Clivey,

I'd be interested in how much they charge you for some pipes to be made, I need ones for full length cans though, like you currently have and that Forde has claimed interest in.

If for some reason it works out cheaper for them to make up more than one set give me a shout and I'll have some made up too. (depending on cost)

Cheers Steve

To all....my cans are now sold, thanks for the enquiries.