Page 2 of 2
Re: Newbie
Posted: Wed Aug 08, 2012 11:02 am
by warlock
Hi
Just picked up a Valderado Clutch cover on the bay... It is exactly the same apart form the water pump which i can just use the original.
It also has a little breather coming from the water pump bearing case, which is sealed so must just be a breather to the shaft???
So hopefully i might be able to start this beauty sooner than i thought.
Re: Newbie
Posted: Wed Aug 08, 2012 8:44 pm
by tony.mon
warlock wrote:Hi
Just picked up a Valderado Clutch cover on the bay... It is exactly the same apart form the water pump which i can just use the original.
It also has a little breather coming from the water pump bearing case, which is sealed so must just be a breather to the shaft???
So hopefully i might be able to start this beauty sooner than i thought.
Yes, the little breather (either just a hole or a 90 degree bit of tube) is to allow any coolant seeping past the ceramic bearing to escape rather than going into the oil.
Re: Newbie
Posted: Tue Aug 21, 2012 6:15 pm
by sirch345
Welcome aboard Neil
Chris.
Re: Newbie
Posted: Wed Aug 22, 2012 3:39 pm
by warlock
Clutch cover on and she is running, took a good battery charge and a gallon of fuel, but she is running after two years of being off road.
Just the exhausts to sort... I found two sets in a day and now have a decision to make carbon can Co or Vipers???
Re: Newbie
Posted: Wed Aug 22, 2012 11:17 pm
by tony.mon
Nice one, a bike back from the dead.
Now check the oil level; it always drops half a litre after being started the first time.....
Re the can choice- Vipers, if they're ali, Ti or SS sleeves, but CCC's if they're carbon fibre.
Just my own preferences, neither will disappoint.
Re: Newbie
Posted: Thu Aug 23, 2012 9:55 am
by sirch345
warlock wrote:Clutch cover on and she is running, took a good battery charge and a gallon of fuel, but she is running after two years of being off road.
Just the exhausts to sort... I found two sets in a day and now have a decision to make carbon can Co or Vipers???
Well done
I can't help you on those makes of cans,
Chris.
Re: Newbie
Posted: Thu Aug 23, 2012 9:25 pm
by warlock
Yeh I notice the level is down slightly, I had the sump off too so she had a proper clean out. I must top her up before i start it again.
In the end bought both cans, will have to sell one set on ebay or hee once decided.
Re: Newbie
Posted: Thu Aug 23, 2012 11:01 pm
by VTRDark
Well done. Have you got some pics, so we can take the piss out the colour.
(:-})